Characterization of a parallel-beam CCD optical-CT apparatus for 3D radiation dosimetry

摘要

3D measurement of optical attenuation is of interest in a variety of fields of biomedical importance, including spectrophotometry, optical projection tomography ( OPT) and analysis of 3D radiation dosimeters. Accurate, precise and economical 3D measurements of optical density ( OD) are a crucial step in enabling 3D radiation dosimeters to enter wider use in clinics. Polymer gels and Fricke gels, as well as dosimeters not based around gels, have been characterized for 3D dosimetry over the last two decades. A separate problem is the verification of the best readout method. A number of different imaging modalities ( magnetic resonance imaging ( MRI), optical CT, x-ray CT and ultrasound) have been suggested for the readout of information from 3D dosimeters. To date only MRI and laser-based optical CT have been characterized in detail. This paper describes some initial steps we have taken in establishing charge coupled device (CCD)-based optical CT as a viable alternative to MRI for readout of 3D radiation dosimeters. The main advantage of CCD-based optical CT over traditional laser-based optical CT is a speed increase of at least an order of magnitude, while the simplicity of its architecture would lend itself to cheaper implementation than both MRI and laser-based optical CT if the camera itself were inexpensive enough. Specifically, we study the following aspects of optical metrology, using high quality test targets: (i) calibration and quality of absorbance measurements and the camera requirements for 3D dosimetry; ( ii) the modulation transfer function ( MTF) of individual projections; ( iii) signal-to-noise ratio (SNR) in the projection and reconstruction domains; ( iv) distortion in the projection domain, depth-of-field (DOF) and telecentricity. The principal results for our current apparatus are as follows: ( i) SNR of optical absorbance in projections is better than 120: 1 for uniform phantoms in absorbance range 0.3 to 1.6 (and better than 200: 1 for absorbances 1.0 to 3.5 with the test target and a novel absorbance range extension method), ( ii) the spatial resolution is shown to be at worst 0.5 mm ( and often better than this) with an associated DOF of 8 cm, iii) the SNR of uniform phantoms in reconstruction domain is above 80: 1 ( one standard deviation) over an absorbance dynamic range of 0.3 to 1.6, (iv) the apparatus is telecentric and without distortion. Finally, a sample scan and reconstruction of a scan of a PRESAGE (TM) dosimeter are shown, demonstrating the capabilities of the apparatus.