...
首页> 外文期刊>Ocean science >The analysis of large-scale turbulence characteristics in the Indonesian seas derived from a regional model based on the Princeton Ocean Model
【24h】

The analysis of large-scale turbulence characteristics in the Indonesian seas derived from a regional model based on the Princeton Ocean Model

机译:基于普林斯顿海洋模型的区域模型对印度尼西亚海域大规模湍流特征的分析

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Turbulence characteristics in the Indonesian seas on the horizontal scale of order of 100 km were calculated with a regional model of the Indonesian seas circulation in the area based on the Princeton Ocean Model (POM). As is well known, the POM incorporates the Mellor-Yamada turbulence closure scheme. The calculated characteristics are: twice the turbulence kinetic energy per unit mass, q2; the turbulence master scale, ℓ; mixing coefficients of momentum, KM; and temperature and salinity, KH; etc. The analyzed turbulence has been generated essentially by the shear of large-scale ocean currents and by the large-scale wind turbulence. We focused on the analysis of turbulence around important topographic features, such as the Lifamatola Sill, the North Sangihe Ridge, the Dewakang Sill, and the North and South Halmahera Sea Sills. In general, the structure of turbulence characteristics in these regions turned out to be similar. For this reason, we have carried out a detailed analysis of the Lifamatola Sill region because dynamically this region is very important and some estimates of mixing coefficients in this area are available. Briefly, the main results are as follows. The distribution of q2 is quite adequately reproduced by the model. To the north of the Lifamatola Sill (in the Maluku Sea) and to the south of the Sill (in the Seram Sea), large values of q2 occur in the deep layer extending several hundred meters above the bottom. The observed increase of q2 near the very bottom is probably due to the increase of velocity shear and the corresponding shear production of q2 very close to the bottom. The turbulence master scale, ℓ, was found to be constant in the main depth of the ocean, while ℓ rapidly decreases close to the bottom, as one would expect. However, in deep profiles away from the sill, the effect of topography results in the ℓ structure being unreasonably complicated as one moves towards the bottom. Values of 15 to 20 - 10-4 m2 s??'1 were obtained for KM and KH in deep water in the vicinity of the Lifamatola Sill. These estimates agree well with basin-scale averaged values of 13.3 - 10-4 m2 s??'1 found diagnostically for KH in the deep Banda and Seram Seas (Gordon et al., 2003) and a value of 9.0 - 10-4 m2 s??'1 found diagnostically for KH for the deep Banda Sea system (van Aken et al., 1988). The somewhat higher simulated values can be explained by the presence of steep topography around the sill.
机译:使用普林斯顿海洋模型(POM),使用该区域印尼海洋环流的区域模型,计算了水平范围为100 km的印尼海洋湍流特征。众所周知,POM采用了Mellor-Yamada湍流封闭方案。计算出的特性为:单位质量湍流动能的两倍, q 2;湍流总尺度,&ell ;;动量混合系数, K M;温度和盐度, K H;所分析的湍流基本上是由大规模洋流的切变和大规模风湍流产生的。我们专注于分析重要地形特征周围的湍流,例如Lifamatola坎,北部Sangihe岭,Dewakang坎,以及北和南Halmahera海坎。通常,在这些区域中的湍流特性的结构被证明是相似的。因此,我们对Lifamatola Sill地区进行了详细分析,因为该地区在动态上非常重要,并且可以对该地区的混合系数进行一些估算。 简要地,主要结果如下。模型充分再现了 q 2的分布。在利法马图拉基尔(Maluku海)的北部和基尔(塞拉姆海)的南部,较大的 q 2值出现在深水层上方,延伸了数百米。底部。在最底部附近观察到的 q 2的增加可能是由于速度剪切的增加以及在非常接近底部的情况下相应的 q 2剪切产生。发现湍流主尺度ℓ在海洋的主要深度是恒定的,而ℓ则是。正如人们所期望的那样,在底部附近迅速下降。但是,在远离窗台的较深剖面中,地形的影响导致ℓ。当人们向底部移动时,结构就会变得不合理地复杂。在Lifamatola窗台附近的深水中, K M和 K H的取值为15到20-10-4 m2 s ??'1。这些估计值与班达深海和塞拉姆海深处诊断为 K H的流域规模平均值13.3-10-4 m2 s ??'1相吻合(Gordon等,2003)。在班达海深层系统诊断出的 K H值为9.0-10-4 m2 s ??'1(van Aken等,1988)。较高的模拟值可以通过门槛周围陡峭的地形来解释。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号