Phosphated Alumina Catalysts: Surface Properties and Reactivity towards 2-PrOH Decomposition

摘要

The influence of the type of precursor, the phosphate content, as well as the source of phosphate ions on the surface texture, acidity, and catalytic activity of phosphated aluminas has been described. Phosphated alumina catalysts were prepared by impregnating two different precursors with two different sources of phosphate in different loading levels w = 3, 6, and 10% PO_4~(3-). The characterisation of the catalyst was performed using X-ray powder diffraction (XRD), thermal analysis (TG), and nitrogen adsorption-desorption methods at 77 K. The surface acidity of the catalysts has been studied by FT-IR spectroscopy of adsorbed pyridine at different temperatures. Moreover, the activity in the catalytic decomposition of isopropanol (2-PrOH) has been investigated at 520 K. Investigation of the surface properties shows that the addition of phosphate ions does not change the crystal phase (gamma-phase) and the samples prepared from gel and phosphoric acid have the highest surface area. An FT-IR study of pyridine adsorption shows both Lewis and Bronsted acid sites on the surface of the samples prepared from gel, while only Lewis acid sites are detected on the samples prepared from crystalline oxide. The catalytic activity by 2-PrOH conversion shows that the conversion of 2-PrOH as well as the selectivity towards propene formation increases from w = 3 to 6% followed by a decline for w = 10%. Moreover, the strongest activity was detected in case of phosphated alumina gel with w = 6% which gives 97.3% propene and 96.1% conversion of 2-PrOH.