...
首页> 外文期刊>Metallurgical and Materials Transactions, A. Physical Metallurgy and Materials Science >The Role of Local Microstructure on Small Fatigue Crack Propagation in an α + β Titanium Alloy, Ti-6Al-2Sn-4Zr-6Mo
【24h】

The Role of Local Microstructure on Small Fatigue Crack Propagation in an α + β Titanium Alloy, Ti-6Al-2Sn-4Zr-6Mo

机译:局部组织对α+β钛合金Ti-6Al-2Sn-4Zr-6Mo中小疲劳裂纹扩展的作用

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Microstructural origins of the variability in fatigue lifetime observed in the high- and very-high-cycle fatigue regimes in titanium alloys were explored by examining the role of microstructural heterogeneity (neighborhoods of grains with similar crystallographic orientations or microtex-ture) on the initiation and early growth of fatigue cracks in Ti-6246. Ultrasonic fatigue of focused ion beam (FIB) micronotched samples was used to investigate long lifetime (107 to 109) behavior for two microstructural conditions: one with microtexture and one without micro-texture. For specimens containing notches of nominally 20 μm in length, fatigue crack initiation in the microtextured material was most likely to occur from notches placed in neighborhoods with a microtexture favorably oriented for easy basal slip. Initiation lifetimes in the untextured material with similar sized notches were, on average, slightly greater than those for the microtextured condition. In both materials, the crack-initiation lifetime from micronotches of length 2c > 20 μm was a very small fraction (<1 pct) of the measured fatigue lifetime for unnotched specimens. Furthermore, in the microtextured condition, small fatigue crack propagation rates did not correlate with the microtextured regions and did not statistically differ from average small crack growth rates in the untextured material. As the micronotch size was reduced below 20 μm, fatigue crack initiation was controlled by microstructure rather than by FIB-machined defects. Finally, predictions of the fraction of life consumed in small and long fatigue crack growth from preexisting cracks nominally equivalent in size to the micronotches was compared with the measured fatigue life of unnotched specimens. The predicted range of lifetimes when factoring in the experimentally observed variability in small fatigue crack growth, only accounted for 0.1 pct of the observed fatigue lifetime variability. These findings indicate that in the high-and very-high-cycle fatigue regimes, fatigue life is dominated by crack initiation and that the variation in the initiation lifetime is responsible for the observed variation in total fatigue life.
机译:通过检查微观结构异质性(具有相似晶体学取向或微晶构象的晶粒的邻域)在引发和形成过程中的作用,探索了钛合金在高循环和超高循环疲劳状态下观察到的疲劳寿命变化的微观结构起源。 Ti-6246中疲劳裂纹的早期生长。聚焦离子束(FIB)微凹口样品的超声疲劳用于研究两种微观结构条件下的长寿命(107至109)行为:一种具有微纹理,一种没有微纹理。对于标称长度为20μm的凹口的试样,微纹理化材料中的疲劳裂纹萌生最有可能是由于放置在具有有利于基底滑移的有利方向的微纹理附近的凹口引起的。平均而言,在具有类似缺口的未织构材料中,其起始寿命平均比在微织构条件下的起始寿命长一些。在这两种材料中,长度为2c> 20μm的微槽口的裂纹萌生寿命仅是无缺口样品疲劳寿命的很小一部分(<1 pct)。此外,在微织构状态下,小的疲劳裂纹扩展速率与微织构区域不相关,并且与非织构材料中的平均小裂纹扩展速率没有统计学差异。随着微缺口尺寸减小到20μm以下,疲劳裂纹的萌生是通过微观结构而不是通过FIB加工的缺陷来控制的。最后,将名义上与微缺口尺寸相等的已存在裂纹的疲劳寿命的长短预测与未缺口试样的疲劳寿命进行了比较。当在小疲劳裂纹扩展中考虑到实验观察到的变异性时,预测寿命范围仅占观察到的疲劳寿命变异性的0.1%。这些发现表明,在高和非常高循环疲劳状态下,疲劳寿命受裂纹萌生的支配,并且萌生寿命的变化是造成总疲劳寿命变化的原因。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号