首页> 外文期刊>Medical dosimetry: official journal of the American Association of Medical Dosimetrists >A treatment planning investigation into the dosimetric effects of systematic prostate patient rotational set-up errors.
【24h】

A treatment planning investigation into the dosimetric effects of systematic prostate patient rotational set-up errors.

机译:治疗计划调查系统性前列腺病人旋转设置错误的剂量效应。

获取原文
获取原文并翻译 | 示例
       

摘要

The purpose of this study was to investigate the potential dosimetric effects of systematic rotational setup errors on prostate patients planned according to the RTOG P-0126 protocol, and to identify rotational tolerances about either the anterior-posterior (AP) or left-right (LR) axis, under which no correction in setup is required. Eight 3-dimensional conformal radiation therapy (3D-CRT) treatment plans were included in the study, half planned to give 7020 cGy in 39 fractions (P-0126 Arm 1) and the other half planned to give 7920 cGy in 44 fractions (P-0126 Arm 2). Systematic rotations of the pelvic anatomy were simulated in a commercial treatment planning system by rotating opposing apertures in the opposite direction to the simulated anatomy rotation. Rotations were incremented in steps of 2.5 degrees to a maximum of +/-5.0 degrees and +/-10.0 degrees about the AP and LR axis respectively. Dose distributions were evaluated with respect to the planning objectives set out in the P-0126 protocol. For patients on Arm 2 of the study, maintaining the prescribed dose to 98% of the PTV was found to be problematic for superior-end-posterior rotations beyond 5.0 degrees . The results also show that maintaining a rectal dose less than 7500 cGy to 15% of the volume can become problematic for cases of small rectal volume and large superior-end-anterior rotations. We found that setting rotational tolerances will depend on which Arm of the protocol the patient is, and how well the initial plan meets the protocol objectives. In general, we conclude that for rotations about the AP axis, no tolerance level is required; however, cases presenting extreme rotations should be investigated as routine practice. For rotations about the LR axis, we conclude that a tolerance level for patients on Arm 2 of the protocol should be set at +/-5.0 degrees . This tolerance represents the systematic setup error which would require correction if a variation to the initial plan was deemed unacceptable.
机译:这项研究的目的是调查根据RTOG P-0126协议计划的系统性旋转设置错误对计划中的前列腺患者的潜在剂量学影响,并确定前后(AP)或左右(LR)的旋转公差)轴,无需进行设置校正。这项研究包括了8个3D立体适形放射治疗(3D-CRT)治疗计划,一半计划以39个分数(P-0126 Arm 1)给予7020 cGy,另一半计划以44分数给予7920 cGy(P -0126机械臂2)。在商业治疗计划系统中,通过沿与模拟解剖结构旋转方向相反的方向旋转相对的孔,来模拟骨盆解剖结构的系统旋转。旋转分别以2.5度为步长,分别绕AP和LR轴增加+/- 5.0度和+/- 10.0度。根据P-0126协议中列出的计划目标评估了剂量分布。对于研究第2组的患者,将处方剂量维持在PTV的98%被认为对于上-后-后旋转超过5.0度是有问题的。结果还表明,对于较小的直肠体积和较大的上-前-前旋转,将直肠剂量保持在小于7500 cGy的体积的15%会成为问题。我们发现,设置旋转公差将取决于患者是方案的哪一部分,以及初始计划能否满足方案的目标。通常,我们得出结论,对于绕AP轴旋转,不需要公差等级;但是,出现极端轮换的案件应作为常规做法进行调查。对于绕LR轴的旋转,我们得出结论,方案第2组患者的耐受水平应设置为+/- 5.0度。该公差代表系统设置误差,如果认为初始计划的变化不可接受,则需要进行校正。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号