...
首页> 外文期刊>Geochimica et Cosmochimica Acta: Journal of the Geochemical Society and the Meteoritical Society >Bubble-induced porewater mixing: A 3-D model for deep porewater irrigation
【24h】

Bubble-induced porewater mixing: A 3-D model for deep porewater irrigation

机译:气泡引起的孔隙水混合:深层孔隙水灌溉的3-D模型

获取原文
获取原文并翻译 | 示例

摘要

Porewater data from vent sites of the northeastern shelf off Sakhalin Island, Sea of Okhotsk, exhibit bottom-water concentrations down to a sediment depth of up to 300 cm. Below this depth, solute concentrations rapidly change due to methanogenesis and anaerobic methane oxidation (AMO). The profile shapes suggest an irrigation-like process that mixes on a meter scale. At these sites active gas emanation into the overlying water column and near-surface gas hydrates are commonly observed. We propose that methane gas bubbles rise through the soft surface sediments and cause mixing of the porewater. Mathematically, the bubble-induced irrigation can be described by eddy diffusion enhancing the diffusive transport of solutes by several orders of magnitude. A 3-D numerical transport-reaction model was developed to investigate the parameters defining the mixing process, such as bubble rise velocity, tube size, tube distribution in the sediment, and ebullition frequency. Model consistency with the field data requires eddy diffusivities >= 1 X 10(5) cm(2) /a, tube densities of >4 tubes/m(2) (equivalent to a tube spacing of <40 cm), active gas seepage for more than a few weeks or months, and moderate to low diagenetic reaction rates of solutes. The corresponding methane gas fluxes that are predicted from the results of the model realizations range from 1 X10(3)-5 x 10(5) L/(m(2) a). Due to bubble mixing, solute fluxes in these sediments are increased by a factor of 3 and the maximum AMO rate by a factor of 7. (c) 2007 Elsevier Ltd. All rights reserved.
机译:来自鄂霍次克海萨哈林岛东北部东北架子喷口处的孔隙水数据显示,底水浓度低至沉积深度达300厘米。在此深度以下,由于甲烷生成和厌氧甲烷氧化(AMO),溶质浓度快速变化。轮廓形状表明类似灌溉的过程在米级上混合。在这些地点,通常观察到有活性气体散发到上层水柱和近地表的天然气水合物中。我们建议甲烷气泡通过软的表面沉积物上升并引起孔隙水的混合。在数学上,可以通过涡流扩散将溶质的扩散传输提高几个数量级来描述气泡诱导的冲洗。建立了3-D数值传输反应模型,以研究定义混合过程的参数,例如气泡上升速度,管子尺寸,管子在沉积物中的分布以及沸腾频率。模型与现场数据的一致性要求涡流扩散率> = 1 X 10(5)cm(2)/ a,管密度> 4管/ m(2)(相当于<40 cm的管间距),活性气体渗漏持续数周或数月,并且溶质的成岩反应速率中等至低。根据模型实现的结果预测的相应甲烷气体通量范围为1 X10(3)-5 x 10(5)L /(m(2)a)。由于气泡的混合,这些沉积物中的溶质通量增加了3倍,最大AMO速率增加了7倍。(c)2007 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号