...
首页> 外文期刊>Geochimica et Cosmochimica Acta: Journal of the Geochemical Society and the Meteoritical Society >Quartz solubility in H2O-NaCl and H2O-CO2 solutions at deep crust-upper mantle pressures and temperatures: 2-15 kbar and 500-900 degrees C
【24h】

Quartz solubility in H2O-NaCl and H2O-CO2 solutions at deep crust-upper mantle pressures and temperatures: 2-15 kbar and 500-900 degrees C

机译:在深地壳-上地幔压力和温度下,石英在H2O-NaCl和H2O-CO2溶液中的溶解度:2-15 kbar和500-900摄氏度

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The solubility of quartz in H2O-NaCl solutions was measured at 2, 4.35, 10 and 15 kbar and 500-900 degrees C, and at NaCl concentrations up to halite saturation, usually greater than 75 wt.%. Quartz solubility was also measured in CO2-H2O solutions at 10 kbar and 800 degrees C. Solubilities were determined by weight loss of ground and polished quartz crystal fragments which were equilibrated with solutions in Pt envelopes for one to four days and then rapidly quenched. Experiments at 2 kbar were made with externally heated cold-seal apparatus; higher pressure experiments were done in a 3/4 inch-diameter piston-cylinder apparatus with NaCl pressure medium and graphite heater sleeve. Equilibrium solubility was demonstrated in several ways, and the present results reproduce those of Manning (1994) in pure H2O at selected conditions. At pressures below 4 kbar, NaCl in solution causes an initial "salting-in", or quartz solubility enhancement, which, at 2 kbar and 700 degrees C, persists to concentrations as great as 70 wt.% NaCl before quartz solubility again becomes as low as in pure H2O. The maximum solubility occurs at X(H2O) similar to 0.9 and is 50% higher than in pure H2O. At 4.35 kbar and 700 degrees C, however, quartz solubility decreases slightly with initial NaCl concentration, and then begins to drop rapidly with increasing salinity beyond 45 wt.% NaCl. At 10 and 15 kbar there is a steep initial decline in silica molality at all temperatures in the range 500-900 degrees C, leveling off at higher NaCl concentrations. There is thus a pronounced change in solution behavior with pressure, from initial salting-in below 4 kbar to monotonic salting-out above 5 kbar. This pressure-induced change in silica solubility parallels the sharp decrease in H2O activity in NaCl solutions in the same pressure range found by Aranovich and Newton (1996). Therefore, the pressure-induced change in silica solubility is inferred to be a consequence of the dissociation of the neutral NaCl degrees complex to Na+ and Cl- as solution densities increase above about 0.7 gm/cm(3). At very high salinities, approaching halite saturation, the isobars of quartz solubility as a function of NaCl mole fraction at 700 degrees C converge, indicating that, for hypersaline fluids having the constitution of molten salts, pressure has only a minor effect on quartz solubility. Quartz solubility at 10 kbar shows exponential decline with increasing salinity at all temperatures in the range 500 degrees C to 900 degrees C. This is the expected behavior of a two-component solvent, in which quartz is sparingly soluble in one component. At 10 kbar, isotherms of log silica molality versus H2O mole fraction are linear between X(H2O) = 1.0 and 0.5, but begin to curve to lower values at 900 degrees C, where high salinities are attained before halite saturation occurs. This behavior implies that the solute silica species is a hydrate that becomes progressively destabilized at low H2O concentrations of the solvent. Plots of log silica molality versus log H2O activity suggest that the solute species is neutral H4SiO4 with no additional solvated H2O molecules, assuming no Na-SiO2 complexing. The solubility of quartz in CO2-H2O fluids at 800 degrees C and 10 kbar is much smaller than in NaCl solutions at the same P,T and H2O activity. Thermodynamic analysis suggests that the solute species in CO2-H2O fluids is H4SiO4 with 1-3 solvated H2O molecules, which is similar to the solute behavior inferred by Walther and Orville (1983) in CO2 and Ar solutions with H2O at lower pressures. The present results show that SiO2 will partition very strongly into a concentrated salt solution in deep crust-upper mantle metamorphic and metasomatic processes, in preference to a coexisting immiscible CO2-rich fluid. The much greater permeability of silicate rocks for salt solutions than for CO2-rich solutions, together with the much higher solubility of silica-rich phases in the former, could be an imp
机译:石英在H2O-NaCl溶液中的溶解度是在2、4.35、10和15 kbar以及500-900摄氏度的温度下测量的,并且在NaCl浓度下达到盐酸盐饱和度(通常大于75 wt。%)。还在10 kbar和800摄氏度的CO2-H2O溶液中测量了石英的溶解度。溶解度是通过将磨碎的和抛光的石英晶体碎块的重量损失确定的,将这些碎碎的石英晶体碎块与Pt包膜中的溶液平衡一到四天,然后迅速淬灭。使用外部加热的冷封设备在2 kbar的压力下进行实验;在具有NaCl压力介质和石墨加热器套筒的3/4英寸直径的活塞缸设备中进行了更高压力的实验。平衡溶解度通过多种方式得到证明,目前的结果重现了Manning(1994)在选定条件下在纯H2O中的溶解度。在低于4 kbar的压力下,溶液中的NaCl引起初始的“盐析”或石英溶解度增强,在2 kbar和700摄氏度下,NaCl的浓度一直保持到70 wt。%,直到石英溶解度再次达到与纯水一样低。最大溶解度出现在X(H2O)处,与0.9相似,比纯H2O高50%。然而,在4.35 kbar和700摄氏度下,石英溶解度随初始NaCl浓度而略有降低,然后随着盐度增加至超过45 wt。%NaCl而开始迅速下降。在10和15 kbar时,在500-900摄氏度范围内的所有温度下,二氧化硅的摩尔浓度都会急剧下降,在较高的NaCl浓度下会趋于平稳。因此,溶液行为随压力发生了显着变化,从最初的盐析低于4 kbar到单调盐析超过5 kbar。在Aranovich和Newton(1996)发现的相同压力范围内,这种压力引起的二氧化硅溶解度变化与NaCl溶液中H2O活性的急剧下降平行。因此,当溶液密度增加到大约0.7 gm / cm以上时,可以推断出压力引起的二氧化硅溶解度变化是中性NaCl度络合物解离成Na +和Cl-的结果(3)。在非常高的盐度下(接近盐饱和度),石英溶解度的等压线随NaCl摩尔分数在700摄氏度的函数而收敛,这表明,对于具有熔融盐成分的高盐度流体,压力对石英溶解度的影响很小。在500°C至900°C范围内的所有温度下,石英在10 kbar的溶解度均随着盐度的增加呈指数下降。这是两组分溶剂的预期行为,其中石英微溶于一种组分。在10 kbar时,对数二氧化硅摩尔浓度对H2O摩尔分数的等温线在X(H2O)= 1.0和0.5之间呈线性关系,但在900摄氏度时开始弯曲为较低的值,在此之前,在盐酸盐饱和之前达到了高盐度。此行为表明,二氧化硅的溶质是在水的低H2O浓度下逐渐变得不稳定的水合物。对数二氧化硅摩尔浓度对log H2O活性的图表明,假设没有Na-SiO2络合,溶质种类为中性H4SiO4,没有其他溶剂化的H2O分子。石英在800°C和10 kbar的CO2-H2O流体中的溶解度比在相同的P,T和H2O活性下的NaCl溶液小得多。热力学分析表明,CO2-H2O流体中的溶质种类为具有1-3个溶剂化H2O分子的H4SiO4,这与Walther和Orville(1983)在较低压力下的H2O的CO2和Ar溶液中的溶质行为相似。目前的结果表明,在深地壳-上地幔变质和变质过程中,SiO2会非常强烈地分配到浓盐溶液中,而不是共存的不混溶的富含CO2的流体。盐溶液中硅酸盐岩石的渗透性比富CO2溶液大得多,而富二氧化硅相在前者中的溶解度更高

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号