Formation mechanism and control of MgO center dot Al2O3 inclusions in non-oriented silicon steel

摘要

On the basis of the practical production of non-oriented silicon steel, the formation of MgO center dot Al2O3 inclusions was analyzed in the process of "basic oxygen furnace (BOF) -> RH -> compact strip production (CSP)". The thermodynamic and kinetic conditions of the formation of MgO center dot Al2O3 inclusions were discussed, and the behavior of slag entrapment in molten steel during RH refining was simulated by computational fluid dynamics (CFD) software. The results showed that the MgO/Al2O3 mass ratio was in the range from 0.005 to 0.017 and that MgO center dot Al2O3 inclusions were not observed before the RH refining process. In contrast, the MgO/Al2O3 mass ratio was in the range from 0.30 to 0.50, and the percentage of MgO center dot Al2O3 spinel inclusions reached 58.4% of the total inclusions after the RH refining process. The compositions of the slag were similar to those of the inclusions; furthermore, the critical velocity of slag entrapment was calculated to be 0.45 m center dot s(-1) at an argon flow rate of 698 L center dot min(-1), as simulated using CFD software. When the test steel was in equilibrium with the slag, [Mg] was 0.00024wt%-0.00028wt% and [Al]s was 0.31wt%-0.37wt%; these concentrations were theoretically calculated to fall within the MgO center dot Al2O3 formation zone, thereby leading to the formation of MgO center dot Al2O3 inclusions in the steel. Thus, the formation of MgO center dot Al2O3 inclusions would be inhibited by reducing the quantity of slag entrapment, controlling the roughing slag during casting, and controlling the composition of the slag and the MgO content in the ladle refractory.