...
首页> 外文期刊>Earth and Planetary Science Letters: A Letter Journal Devoted to the Development in Time of the Earth and Planetary System >Hydrothermal cooling of midocean ridge axes: Do measured and modeled heat fluxes agree?
【24h】

Hydrothermal cooling of midocean ridge axes: Do measured and modeled heat fluxes agree?

机译:中洋脊轴的水热冷却:测量和模拟的热通量是否一致?

获取原文
获取原文并翻译 | 示例

摘要

Accurate estimates of near-axis hydrothermal cooling are keys to understanding many geological, chemical, and biological processes at midocean ridges. At present, however, field observations (H, heat flux/vent field) are few and imprecise, and model results (H-m, heat flux/km of axis) vary widely depending on assumptions about crustal formation, crustal composition, and the cooling efficiency and spatial and temporal extent of hydrothermal circulation. In this paper I compare all published vent-field-scale measurements of H to a range of published H,, for slow (<= 40 mm/yr) and fast (> 40 mm/yr) ridges to assess the present state of knowledge about the magnitude of near-axis hydrothermal cooling. H has been evaluated 28 times, either by point measurements using inventories of individual sources (362 +/- 552 MW, n = 12 measurements), or by integrated measurements using water column observations (876 +/- 1011 MW, n = 16). Comparable estimates of mean vent field "expected H' at any spreading rate can be derived by merging H,, from various models with the predicted global inventory of active vent sites. These estimates range from similar to 1-1.5 GW/field and are approximately constant for all spreading rates. This range agrees with the best-constrained results of H from slow-ridoe vent fields (1669 +/- 1354 MW) but is considerably higher than those from fast ridges (245 +/- 170 MW). Inferences about the spatial and temporal variability of H can be gained by defining the parameter L=H/H-m, equivalent to the axis length needed to continuously power a hydrothermal field. The resultant large L values (13-333 km for slow ridges, 1-32 km for fast) demand punctuated cooling, where for short periods H > H-m. The percentage of time that a given vent field might be active can be speculatively estimated by dividing L by the length of axis the field cools. Examples of this percentage range from a low of < similar to 5% for a slow-ridge field to > similar to 50% for some fast-ridge fields. Published by Elsevier B.V.
机译:准确估算近轴热液冷却是了解洋中脊许多地质,化学和生物过程的关键。但是,目前,实地观测(H,热通量/通气量)很少且不精确,模型结果(Hm,热通量/轴的km)取决于地壳形成,地壳成分和冷却效率的假设而有很大不同。热液循环的时空范围。在本文中,我比较了所有已发布的H气孔尺度测量值与已发布的H范围,以比较缓慢的(<= 40 mm / yr)和快速的(> 40 mm / yr)脊来评估当前的知识状态关于近轴水热冷却的大小。对H进行了28次评估,可以通过使用单个来源的清单进行点测量(362 +/- 552 MW,n = 12测量),或者通过使用水柱观测的综合测量(876 +/- 1011 MW,n = 16)进行评估。 。可以通过将各种模式的H与合并的活动排放点的全球清单进行合并,得出H在任何扩展速率下的平均排放场“预期H”的可比估计值。这些估计值的范围大约为1-1.5 GW /场,大约为该范围与慢波泄流孔场(1669 +/- 1354 MW)产生的H的最佳约束结果一致,但远高于快脊(245 +/- 170 MW)的H的最佳约束结果。可以通过定义参数L = H / Hm来获得关于H的时空变化的信息,该参数等于连续为热液场提供动力所需的轴长。所得的大L值(慢脊13-333 km,1-快速(32 km)时需要按要求进行点冷却,在短期内H> Hm。通过将L除以该区域冷却的轴长,可以推测性地估计给定通风孔可能处于活动状态的时间百分比。从<的低至慢脊场为5%,而某些快脊场为> 50%。由Elsevier B.V.发布

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号