...
首页> 外文期刊>International Journal of Pharmaceutics >The relationship between granule growth mechanism, amount of liquid binder added and properties of the wet powder mass determined using a split bed shear tester.
【24h】

The relationship between granule growth mechanism, amount of liquid binder added and properties of the wet powder mass determined using a split bed shear tester.

机译:使用分流床剪切测试仪测定颗粒生长机理,液体粘合剂的添加量和湿粉团的性质之间的关系。

获取原文
获取原文并翻译 | 示例
           

摘要

The Peschl-split bed shear tester was utilised to study the formation of different liquid states during wet massing for granulation. Using lactose monohydrate as a model bulking agent the threshold between pendular and funicular state was found to be at about 6% (w/w) of liquid binder added to the wet mass, here a 5% colloidal solution of HPMC in water. The upper limit of the funicular state appeared to be at approximately 15% (w/w) of liquid binder. The threshold values obtained from the shear cell measurements did correlate with values obtained from dried granule characteristics such as granule density and compressive Young's modulus determined by Dynamic Mechanical Analysis. The compressive Young's modulus increased with an increasing density of the wet mass during the shear experiments and decreased with an increase in the angle of internal friction. The results suggest that stiffer granules were a result of densification, not the strength of liquid bridge bond formation.
机译:佩斯切尔床剪切测试仪用于研究湿法成粒过程中不同液态的形成。使用乳糖一水合物作为模型填充剂,发现在摆动状态和缆索状态之间的阈值约为添加到湿物料中的液态粘合剂(此处为HPMC在水中的5%胶体溶液)的6%(w / w)。缆索状状态的上限似乎是液体粘合剂的约15%(w / w)。从剪切池测量获得的阈值确实与从干燥颗粒特性(例如通过动态力学分析确定的颗粒密度和压缩杨氏模量)获得的值相关。在剪切实验期间,压缩杨氏模量随着湿物质密度的增加而增加,而随着内摩擦角的增加而降低。结果表明,较硬的颗粒是致密化的结果,而不是液体桥键形成的强度。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号