A method to discretize non-planar fractures for 3D subsurface flow and transport simulations

摘要

A method is presented to discretize inclined non-planar 2D fractures within a 3D finite element grid for subsurface flow and transport simulations. Each 2D fracture is represented as a triangulated surface. Each triangle is then discretized by 2D fracture elements that can be horizontal, vertical or inclined and that can be triangular or rectangular. The 3D grid representing a porous rock formation consists of hexahedra and can be irregular to allow grid refinement. An inclined fracture was discretized by (a) inclined triangles and (b) orthogonal rectangles and flow/transport simulations were run to compare the results. The comparison showed that (i) inclined fracture elements must be used to simulate 2D transient flow, (ii) results of 2D/3D steady-state and 3D transient flow simulations are identical for both discretization methods, (iii) inclined fracture elements must be used to simulate 2D/3D transport because orthogonal fracture elements significantly underestimate concentrations, and (iv) orthogonal elements can be used to simulate 2D/3D transport if fracture permeability is corrected and multiplied by the ratio of fracture surface areas (orthogonal to inclined). Groundwater flow at a potential site for long-term disposal of spent nuclear fuel was simulated where a complex 3D fracture network was discretized with this technique. The large-scale simulation demonstrates that the proposed discretization procedure offers new possibilities to simulate flow and transport in complex 3D fracture networks. The new procedure has the further advantage that the same grid can be used for different realizations of a fracture network model with no need to regenerate the grid.