首页> 外文期刊>Icarus: International Journal of Solar System Studies >Restitution coefficients and sticking velocities of a chondrule analogue colliding on a porous silica layer at impact velocities between 0.1 and 80ms ~(-1)
【24h】

Restitution coefficients and sticking velocities of a chondrule analogue colliding on a porous silica layer at impact velocities between 0.1 and 80ms ~(-1)

机译:软骨素类似物在0.1到80ms〜(-1)的撞击速度下碰撞到多孔二氧化硅层上的恢复系数和粘附速度

获取原文
获取原文并翻译 | 示例
           

摘要

To study the accretional growth of rimmed chondrules and their agglomerates in the solar nebula, we measured the restitution coefficients, ε, and the sticking velocities to a porous silica layer, v _c, by impacting the silica layer with a glass ball at velocities from 0.1 to 80ms ~(-1). We used a porous silica layer covering a basalt block with thicknesses ranging from 1/5 of the glass ball radius to equal to the glass ball radius as a rimmed chondrule analogue, and the porosity of the silica layer was set to be 70%, 80%, 85%, and 90%. Collisional experiments were conducted by means of the free fall method or by the use of a spring gun or a gas gun, allowing us to vary the impact velocity. We used a laser displacement meter to estimate the impact and rebound velocities as well as the acceleration during the collision at impact velocities below 1ms ~(-1). As a result, the sticking velocity, v _c, of 90%- and 85%- porosity layers with a thickness equal to 1/2 of the glass ball diameter was 0.44 and 2.4ms ~(-1), respectively. On the other hand, we found a distinct barrier to sticking for smaller-porosity layers: the silicate layer with a porosity smaller than 80% never exhibited sticking at any impact velocity below 1ms ~(-1). Instead, we observed a rebound effect with restitution coefficients larger than 0.2. In the case of a silica layer with a porosity smaller than 80%, we observed the sub-sticking condition defined by ε<0.1 at velocities extending from 5ms -1 to 70ms ~(-1).
机译:为了研究有边缘的软骨及其附聚体在太阳星云中的增生,我们测量了恢复系数ε以及对多孔二氧化硅层的粘附速度v _c,方法是用玻璃球撞击二氧化硅层,速度为0.1到80ms〜(-1)。我们使用覆盖石英玄武岩块的多孔二氧化硅层作为边缘类软骨材料,其厚度范围为玻璃球半径的1/5等于玻璃球半径,并将二氧化硅层的孔隙率设置为70%,80 %,85%和90%。碰撞实验是通过自由落体法或弹簧枪或气枪进行的,从而使我们能够改变撞击速度。我们使用激光位移计来估计冲击速度和反弹速度以及在碰撞速度低于1ms〜(-1)时的碰撞过程中的加速度。结果,厚度等于玻璃球直径的1/2的90%和85%孔隙率层的粘附速度v _c分别为0.44和2.4ms〜(-1)。另一方面,对于较小孔隙度的层,我们发现了明显的粘附障碍:孔隙率小于80%的硅酸盐层在1ms〜(-1)以下的任何撞击速度下都不会表现出粘附。相反,我们观察到恢复系数大于0.2的反弹效应。在孔隙率小于80%的二氧化硅层的情况下,我们观察到在从5ms -1到70ms〜(-1)的速度下,ε<0.1所定义的亚粘性条件。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号