...
首页> 外文期刊>Applied mathematics and computation >Heat and mass transfer in annular liquid jets: III. Combustion within the volume enclosed by the jet
【24h】

Heat and mass transfer in annular liquid jets: III. Combustion within the volume enclosed by the jet

机译:环形液体射流中的传热和传质:III。在喷嘴封闭的容积内燃烧

获取原文
获取原文并翻译 | 示例
           

摘要

The nonlinear dynamics of and heat and mass transfer processes in annular liquid jets are analyzed by means of a nonlinear system of integrodifferential equations which account for the liquid motion and the gases enclosed by the jet. Both linear and sinusoidal heat and mass addition sources are considered to take place homogeneously within the volume enclosed by the jet's inner interface in an attempt to simulate the combustion of hazardous wastes or materials within this volume. It is shown that the liquid's temprature at the jet's inner interface increases rapidly with linear heat addition, but drops also quickly to its initial value once heat addition is ended, whereas the pressure coefficient and the volume enclosed by the jet increase until they reach a maximum Value and then decrease in an oscillatory manner towards their steady values. For the case of sinusoidal heat addition, it is shown that the pressure coefficient and interfacial concentration, temperature End heat and mass fluxes oscillate in a sinusoidal manner with the same frequency as that of the sinusoidal heat source. It is also shown that mass transfer phenomena are much slower than heat-transfer ones. For the case of linear mass:addition, it is shown that the:temperature of the gases enclosed by the jet first decreases because of dilution and then it increases until it reaches a constant value that corresponds to the same, temperature for the gases and the flowing liquid. The pressure of the gases enclosed by the jet first increases because of mass addition and then slowly decreases because of mass absorption by the jet, (C). 2000 Elsevier Science;Inc. All rights reserved. [References: 11]
机译:借助于积分微分方程的非线性系统分析了环形液体射流的非线性动力学以及传热和传质过程,该系统解释了液体运动和射流所包围的气体。线性和正弦加热和质量增加源均被认为均匀地发生在喷嘴内部界面所包围的容积内,以试图模拟该容积内的危险废物或材料的燃烧。结果表明,射流内部界面处的液体温度随着线性热添加而迅速增加,但是一旦结束热添加,液体的温度也迅速下降至其初始值,而射流所包围的压力系数和体积增加直到达到最大值。值,然后朝着其稳定值摆动。对于正弦热添加的情况,表明压力系数和界面浓度,温度End热和质量通量以与正弦热源相同的频率以正弦形式振荡。还表明传质现象比传热现象慢得多。对于线性质量:加法,表明:由于稀释,射流所包围的气体的温度首先降低,然后升高,直到达到与气体和气体温度相同的恒定值为止。流动的液体。由于质量的增加,射流所包围的气体压力首先增加,然后由于射流的质量吸收而缓慢降低(C)。 2000 Elsevier Science; Inc。版权所有。 [参考:11]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号