首页> 外文期刊>Applied Geochemistry: Journal of the International Association of Geochemistry and Cosmochemistry >Measuring the specific caesium sorption capacity of soils, sediments and clay minerals
【24h】

Measuring the specific caesium sorption capacity of soils, sediments and clay minerals

机译:测量土壤,沉积物和黏土矿物对铯的比吸收能力

获取原文
获取原文并翻译 | 示例
           

摘要

Two methods to quantify the specific Cs sorption capacity of soils and sediments, which is generally believed to be associated with the Frayed Edge Sites (FES) of illitic clay minerals, are described in detail and are critically reviewed. The first method is a direct measurement of the FES capacity, while the second quantifies the combined parameter K-D(Cs) x [K+](= Kc(K -> Cs) x [FES]), i.e. the product of the FES capacity and the affinity of these sites for Cs. Both methods use the bulky AgTU-complex to mask non-specific sorption sites for Cs and are applied to a number of different soils and pure minerals. Measurement of the FES capacity of pure illite is straightforward. It is shown that the measured capacity is independent of the saturating ion, but does depend on particle size. This method could not be successfully applied to a peat bog soil with 90% organic matter, because the necessary correction for non-specific Cs sorption by the large pool of organic exchange sites overpasses the capacity of the small FES fraction. Measurement of the combined parameter K-D(Cs) x [K+] is shown to be more appropriate in such cases. Application of the FES capacity method to the hydrous alu minosilicate mineral allophane, an important soil constituent of Andisols, shows that the AgTU-complex is unable to block all non-specific sorption sites for Cs on this mineral. The K-D(Cs) [K+] measurements show evidence of a very small number of specific Cs sorption sites on allophane, much smaller than inferred from the FES capacity measurement. The FES capacity of the clay mineral vermiculite is difficult to quantify because the high Cs concentrations that are needed to measure the FES capacity probably cause a collapse of the vermiculite interlayers, thereby creating more high-affinity sites for Cs. The K-D(Cs) x [K+] method, in which only trace concentrations of Cs are used, is shown to be more appropriate for soils containing substantial amounts of vermiculite. It is concluded that both the direct FES capacity measurement and the measurement of the combined parameter K-D(Cs) x [K+] can be very useful methods to isolate and characterise Cs-selective sorption sites in soils and sediments, but that results should be interpreted with great care. (c) 2006 Elsevier Ltd. All rights reserved.
机译:详细介绍了两种量化土壤和沉积物对Cs的比吸收能力的方法,这些方法通常被认为与硅质粘土矿物的磨损边缘部位(FES)有关,并对其进行了严格的审查。第一种方法是FES容量的直接测量,而第二种方法则量化组合参数KD(Cs)x [K +](= Kc(K-> Cs)x [FES]),即FES容量与这些站点对Cs的亲和力。两种方法都使用笨重的AgTU复合物来掩盖Cs的非特异性吸附位点,并应用于多种不同的土壤和纯矿物。纯伊利石的FES容量的测量非常简单。结果表明,测得的容量与饱和离子无关,但确实取决于粒径。该方法不能成功地应用于有机物含量为90%的泥炭沼泽土壤,因为通过大量有机交换位点对非特异性Cs吸附的必要校正超过了小FES馏分的容量。在这种情况下,组合参数K-D(Cs)x [K +]的测量显示更为合适。将FES容量法应用到含水水合氨基硅酸铝矿物质的水铝石中,该金属是Andisols的重要土壤成分,表明AgTU复合物无法阻止该矿物上Cs的所有非特异性吸附位点。 K-D(Cs)[K +]测量结果表明,在Allophane上有非常少量的特定Cs吸附位点,比FES容量测量结果要小得多。粘土矿物ver石的FES容量难以量化,因为测量FES容量所需的高Cs浓度可能会导致the石中间层的塌陷,从而为Cs创建更多的高亲和力位点。仅使用痕量Cs的K-D(Cs)x [K +]方法显示对于含有大量of石的土壤更为合适。结论是,直接FES容量测量和组合参数KD(Cs)x [K +]的测量都是分离和表征土壤和沉积物中Cs选择性吸附位点的非常有用的方法,但结果应予解释小心翼翼(c)2006 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号