...
【24h】

Innovative visible light-activated sulfur doped TiO2 films for water treatment

机译:用于水处理的创新型可见光活化硫掺杂TiO2薄膜

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Visible light-activated sulfur doped TiO2 nanocrystalline films were synthesized by a sol-gel method based on the self-assembly technique with nonionic surfactant to control nanostructure and an inorganic sulfur source (i.e., H2SO4). The films were characterized by UV-vis diffuse reflectance, XRD, TEM, Raman, AFM, ESEM, XPS, FT-IR, EDX, EPR and porosimetry. The results showed that the physicochemi-cal properties of the films, such as BET surface area, porosity, crystallite size and pore size distribution could be controlled by the calcination temperature. The highest surface area, smallest crystallite size and narrow pore size distribution were obtained for sulfur doped TiO2 films calcined at 350 °C, which exhibit very smooth surface with minimal roughness (<1 nm). The optical absorption edge of sulfur doped TiO2 was red shifted with indirect bandgap energy of 2.94 eV. Sulfur species distributed uniformly throughout the films were identified both as S~(2-) ions related to anionic substitutional doping of TiO2 as well as S~(6+)/S~(4+) cations, attributed mainly to the presence of surface sulfate groups. EPR measurements revealed a sharp signal at g = 2.004, whose intensity correlated with the sulfur content and most importantly was markedly enhanced under visible light irradiation, implying the formation of localized energy states in the TiO2 band gap due to anion doping and/or oxygen vacancies. In terms of photocatalytic activity, films calcined at 350°C were the most effective for the degradation of hepatotoxin microcystin-LR (MC-LR) under visible light irradiation, while films calcined at 400 °C and 500 °C degraded MC-LR to a lower extent, following the evolution of the sulfur content with calcination temperature. The photocatalytic activity of the sulfur doped TiO2 film was stable during three consecutive experiments under visible light irradiation, confirming the mechanical stability and reusability of the doped nanostructured thin film photocatalysts.
机译:基于溶胶-凝胶法,基于非离子表面活性剂控制无机结构和无机硫源(H2SO4)的自组装技术,通过溶胶-凝胶法合成了可见光活化硫掺杂的TiO2纳米晶薄膜。膜的特征在于紫外可见漫反射,XRD,TEM,拉曼,AFM,ESEM,XPS,FT-IR,EDX,EPR和孔隙率法。结果表明,煅烧温度可以控制薄膜的物理化学性质,如BET表面积,孔隙率,微晶尺寸和孔径分布。在350°C下煅烧的硫掺杂TiO2薄膜具有最大的表面积,最小的微晶尺寸和狭窄的孔径分布,其表面非常光滑,粗糙度最小(<1 nm)。硫掺杂的TiO2的光吸收边缘发生了红移,间接带隙能量为2.94 eV。均匀分布在整个薄膜中的硫物种被确定为与TiO2的阴离子取代掺杂有关的S〜(2-)离子以及S〜(6 +)/ S〜(4+)阳离子,主要归因于表面的存在硫酸盐基团。 EPR测量在g = 2.004处显示了一个锐利的信号,其强度与硫含量相关,最重要的是在可见光照射下显着增强,这意味着由于阴离子掺杂和/或氧空位而在TiO2带隙中形成了局部能态。 。就光催化活性而言,在350°C煅烧的膜对可见光照射下肝毒素微囊藻毒素-LR(MC-LR)的降解最有效,而在400°C和500°C煅烧的膜将MC-LR降解为硫含量随煅烧温度的升高而降低。在可见光照射下的三个连续实验中,硫掺杂的TiO2薄膜的光催化活性稳定,证实了掺杂的纳米结构薄膜光催化剂的机械稳定性和可重复使用性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号