...
首页> 外文期刊>Applied Catalysis, B. Environmental: An International Journal Devoted to Catalytic Science and Its Applications >The direct-indirect kinetic model in photocatalysis: A reanalysis of phenol and formic acid degradation rate dependence on photon flow and concentration in TiO2 aqueous dispersions
【24h】

The direct-indirect kinetic model in photocatalysis: A reanalysis of phenol and formic acid degradation rate dependence on photon flow and concentration in TiO2 aqueous dispersions

机译:光催化中的直接-间接动力学模型:对苯酚和甲酸降解速率的重新分析,其取决于光子流量和TiO2水性分散液中的浓度

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Literature data concerning TiO2 photocatalytic oxidation of two model organic substrates, phenol and formic acid, are shown to be incompatible with the behavior predicted by the Langmuir-Hinshelwood (L-H) kinetic model. These data are reanalyzed in detail from a kinetic/mechanistic point of view to the light of the direct-indirect (D-I) model (D. Monllor-Satoca, R. Gomez, M. Gonzalez-Hidalgo, P. Salvador, Catal. Today 129 (1-2) (2007) 247), developed as an alternative to the L-H model. Two interfacial charge transfer mechanisms are considered by the (D-I) model: the indirect transfer (IT) mechanism, which is concerned with the adiabatic transfer of holes trapped at TiO2 terminal oxygen ions to dissolved substrate species, and the direct transfer (DT) mechanism dealing with the inelastic transfer of free holes to specifically adsorbed substrate species. While IT is the only mechanism taking place in the absence of specific adsorption, both DT and IT mechanisms actuate simultaneously under specific adsorption, although DT prevails on IT at high enough UV illumination intensity. On the experimental basis that in aqueous solution phenol is not specifically adsorbed on TiO2, it is shown that the experimental photodegradation rate dependence on photon flux (p) and phenol concentration (C) is not compatible with a Langmuir type expression, but can be fitted by the photooxidation rate expression (dC/ dt) = [(aC)~2 + 2k_oaρC]~(1/2) - aC, as predicted by the D-I model for IT, where a is an experimental parameter involving the rate constants for electron-hole recombination and transfer of photogenerated electrons and holes at the semiconductor-electrolyte interface. An apparent dependence of a on p and C is observed experimentally. Two possible hypothesis are invoked in order to explain this behaviour:a shift of the TiO2 energy levels, due to an accumulation of electric charge at the semiconductor surface, and/or the partial contribution of inelastic DT of holes to incipiently adsorbed phenol species. Evidence is given that the photooxidation rate of formic acid, which is shown to be specifically adsorbed on TiO2 in the presence of water, depends linearly on p, even at high enough photon flux values, as predicted by the D-I model when DT prevails on IT, but in contradiction with the behavior predicted by the L-H model.
机译:有关两种模型有机底物苯酚和甲酸的TiO2光催化氧化的文献数据显示与Langmuir-Hinshelwood(L-H)动力学模型预测的行为不兼容。从动力学/力学的角度,根据直接-间接(DI)模型(D. Monllor-Satoca,R。Gomez,M。Gonzalez-Hidalgo,P。Salvador,加泰罗尼亚)详细重新分析了这些数据。 129(1-2)(2007)247),替代LH模型。 (DI)模型考虑了两种界面电荷转移机制:间接转移(IT)机制,与TiO2末端氧离子中捕获的空穴的绝热转移到溶解的底物物种有关,以及直接转移(DT)机制处理自由孔向特定吸附的底物物种的非弹性转移。尽管IT是在没有特定吸附的情况下发生的唯一机制,但DT和IT机制在特定吸附下同时启动,尽管DT在IT上具有足够高的紫外线照射强度。实验结果表明,苯酚在水溶液中没有特异性地吸附在TiO2上,表明实验光降解速率对光子通量(p)和苯酚浓度(C)的依赖性与Langmuir型表达式不兼容,但可以拟合。通过光氧化速率表达式(dC / dt)= [(aC)〜2 +2k_oaρC]〜(1/2)-aC,如IT的DI模型所预测的,其中a是涉及电子速率常数的实验参数空穴复合以及光生电子和空穴在半导体-电解质界面处的转移。通过实验观察到a对p和C的明显依赖性。为了解释这种行为,提出了两种可能的假设:由于半导体表面电荷的积累,TiO2能级的移动,和/或空穴的非弹性DT对初期吸附的酚类物质的部分贡献。有证据表明,甲酸的光氧化速率在水存在下被特异性地吸附在TiO2上,即使在足够高的光子通量值下,其线性也取决于p,这是由DT模型在IT上占优势的DI模型所预测的,但与LH模型所预测的行为相矛盾。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号