首页> 外文期刊>Catena: An Interdisciplinary Journal of Soil Science Hydrology-Geomorphology Focusing on Geoecology and Landscape Evolution >Splash erosion affected by initial soil moisture and surface conditions under simulated rainfall
【24h】

Splash erosion affected by initial soil moisture and surface conditions under simulated rainfall

机译:采用模拟降雨下初始土壤水分和表面条件影响的飞溅侵蚀

获取原文
获取原文并翻译 | 示例
           

摘要

Soil erosion by water is one of the most severe soil degradation processes. Splash erosion is the initial stage of soil erosion by water, resulting from the destructive force of rain drops acting on soil surface aggregates. Apart from rainfall properties, constant soil physical properties (texture and soil organic matter) are crucial in understanding the splash erosion. However, there is lack of information about the effect of variable soil properties such as soil initial water content and surface condition (seal formation) on splash erosion. The objective of the present study was to determine how initial water content and surface condition affected soil splash erosion under simulated rainfall. The changes in soil surface condition were characterized by hydraulic variability (saturated hydraulic conductivity) due to surface seal formation. Slit loam and loamy sand soil textures were used in the experiment. The soil samples were collected from the top layer; air dried, and filled into modified Morgan splash cups for splash erosion measurements. Rainfall was created in the laboratory using two types of rainfall simulators covering intensity range from 28 to 54 mm h(-1) and from 35 to 81 mm h(-1). The soil samples were exposed to three consecutive rainfall simulations with different time intervals between simulations and different initial water content and surface conditions (air-dried, wet-sealed, and dry-crusted). Wet-sealed soil samples had up to 70% lower splash erosion rate compared to air-dried samples, due to surface ponding followed by seal formation. A significant decrease in soil saturated hydraulic conductivity indicated the formation of surface seal for silt loam soils. A non-significant decrease in saturated hydraulic conductivity for loamy sand soil was attributed to earlier formation of stable seals. Two different rainfall simulators produced different amount of splash erosion rates; however, the splash erosion development for increasing rainfall intensity was almost equal considering same initial surface condition. These results provide insight into dynamic changes of individual soil parameters affected by rainfall, and could find wider application for more complex soil erosion prediction models.
机译:水土流失是最严重的土壤退化过程之一。溅蚀是水对土壤侵蚀的初始阶段,是雨滴作用于土壤表面团聚体的破坏力造成的。除了降雨特性外,恒定的土壤物理特性(质地和土壤有机质)对于理解溅蚀至关重要。然而,缺乏关于土壤初始含水量和表面条件(封层形成)等可变土壤性质对溅蚀的影响的信息。本研究的目的是确定初始含水量和地表条件如何影响模拟降雨条件下的土壤溅蚀。由于表面密封的形成,土壤表面条件的变化以水力变异性(饱和导水率)为特征。试验中使用了狭缝壤土和壤质砂土壤质地。从表层采集土壤样本;风干后,装入改良的Morgan飞溅杯中进行飞溅侵蚀测量。实验室使用两种类型的降雨模拟器创建降雨,其强度范围为28至54毫米小时(-1)和35至81毫米小时(-1)。将土壤样本暴露于三个连续的降雨模拟中,模拟之间的时间间隔不同,初始含水量和表面条件不同(风干、湿封和干结皮)。与风干样品相比,湿密封土壤样品的溅蚀率低70%,这是由于表面积水,然后形成密封。土壤饱和导水率的显著降低表明粉质壤土表面形成了封层。壤质砂土的饱和导水率没有显著降低,这是由于早期形成了稳定的封层。两种不同的降雨模拟器产生的溅蚀率不同;然而,考虑到相同的初始表面条件,随着降雨强度的增加,溅蚀发展几乎相等。这些结果提供了受降雨影响的单个土壤参数的动态变化,并可能在更复杂的土壤侵蚀预测模型中得到更广泛的应用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号