首页> 外文期刊>Biomass Conversion and Biorefinery >The role of emulsification as pre-treatment on the anaerobic digestion of oleic acid: process performance, modeling, and sludge metabolic properties
【24h】

The role of emulsification as pre-treatment on the anaerobic digestion of oleic acid: process performance, modeling, and sludge metabolic properties

机译:乳化作为对油酸无厌氧消化的预处理的作用:工艺性能,建模和污泥代谢性质

获取原文
获取原文并翻译 | 示例
       

摘要

Oleic acid is the most abundant long-chain fatty acid (LCFA) in nature and the main product of lipid hydrolysis. In this study, the effect of emulsification pre-treatment on the anaerobic digestion of oleic acid was studied using fed-batch mesophilic anaerobic digesters. A high-shear mixer was used to disintegrate oleic acid with whey protein as the emulsifier. The anaerobic digesters were operated with gradually increasing the organic loading rate (OLR) (from 1 to 8 g L(-1)d(-1)), while the influent oleic acid concentration remained at 5 g L-1. COD removal was between 80 and 90% for both digesters; however, the methane yield was significantly higher for the digester treating emulsified oleic acid (0.37 NL g(-1)COD removed), compared to 0.27 NL g(-1)COD for the control digester without emulsification pre-treatment. Non-emulsified oleic acid coalesced inside the digester and formed floating particles with high lipid-content (63%w/w TS). The anaerobic sludge exposed to emulsified oleic acid increased its methanogenic activity. The anaerobic digestion model (ADM1) predicted well the biogas production rate, the concentrations of volatile fatty acids (VFAs), the digesters pH, and the biogas methane content. The maximum specific consumption rate constant (km) for oleic acid was 4 times higher (i.e., from 2 to 8 d(-1)) with the applied emulsification pre-treatment. The application of the ADM1 to the experimental results contributed into elucidating the kinetics of oleic acid biodegradation and quantifying the effect of emulsification pre-treatment.
机译:油酸是最丰富的长链脂肪酸(LCFA)的性质和脂质水解的主要产物。在该研究中,研究了使用FED-批液厌氧消化器研究了乳化预处理对油酸厌氧消化的影响。使用高剪切混合器用乳清蛋白作为乳化剂崩解油酸。厌氧消化器用逐渐增加有机加载速率(OLR)(从1至8g L(-1)d(-1)),而流入的油酸浓度保持在5g L-1。消化器的鳕鱼去除为80%至90%;然而,对于乳化油化油酸(0.37nl G(-1)鳕鱼被除去)的乳化剂处理,甲烷产率显着较高,而无需乳化预处理,则除去0.27nl g(-1)焦点。非乳化油酸在蒸煮器内聚集并形成具有高脂质含量(63%w / w ts)的浮动颗粒。暴露于乳化油酸的厌氧污泥增加了其甲状腺炎活性。厌氧消化模型(ADM1)预测沼气生产率,挥发性脂肪酸(VFA)的浓度,消化器pH和沼气甲烷含量。油酸的最大特异性消耗率常数(km)是施用乳化预处理的4倍(即,从2至8d(-1))。 ADM1对实验结果的应用有助于阐明油酸生物降解的动力学和量化乳化预处理的作用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号