Effects of post-sintering annealing on the microstructure and toughness of hot-pressed SiCf/SiC composites with Al2O3-Y2O3 additions

摘要

This study examined the effects of post-sintering heat treatment on enhancing the toughness of SiCf/SiC composites. Commercially available Tyranno (R) SiC fabrics with contiguous dual 'PyC (inner)-SiC (outer)' coatings deposited on the SiC fibers were infiltrated with a SiC + 10 wt% Al2O3-Y2O3 slurry by electrophoretic deposition. SiC green tapes were stacked between the slurry-infiltrated fabrics to control the matrix volume fraction. Densification of approximately 94% rho theo was achieved by hot pressing at 1750 degrees C, 20 MPa for 2 h in an Ar atmosphere. Sintered composites were then subjected to isothermal annealing treatment at 1100, 1250, 1350, and 1750 degrees C for 5 h in Ar. The correlation between the flexural behavior and microstructure was explained in terms of the in situ-toughened matrix, phase evolution in the sintering additive, role of dual interphases and observed fracture mechanisms. Eitensive fractography analysis revealed interfacial debonding at the hybrid interfaces and matrix cracking as the key fracture modes, which were responsible for the toughening behavior in the annealed SiCf/SiC composites.