...
首页> 外文期刊>CERAMICS INTERNATIONAL >Visible-light active mesoporous, nanocrystalline N,S-doped and co-doped titania photocatalysts synthesized by non-hydrolytic sol-gel route
【24h】

Visible-light active mesoporous, nanocrystalline N,S-doped and co-doped titania photocatalysts synthesized by non-hydrolytic sol-gel route

机译:非水解溶胶 - 凝胶途径合成的可见光活性介孔,纳米晶n,S掺杂和共掺杂二氧化钛光催化剂

获取原文
获取原文并翻译 | 示例
           

摘要

Visible-light active mesoporous N,S-doped and co-doped anatase TiO2 powders were synthesized by non-hydrolytic sol-gel route, starting from TiCl4 and Ti((OPr)-Pr-i)(4) dissolved in cyclohexane or dimethyl sulfoxide, later used as a S-doping agent. After drying in an inert atmosphere, the gels were annealed at 500 degrees C for 3 h, in air or ammonia flow, later used for N-doping. The undoped titania powder, obtained by annealing in air of the cyclohexane-based gel, was also annealed in ammonia to deduce which method is more efficient for N-doping: gel or powder annealing. The post-annealing in air after annealing in ammonia was optimized to attain the best photocatalytic activity for dye degradation under simulated visible light. The size of anatase nanocrystals decreased by doping and the specific surface area of the powders increased. The XPS analysis confirmed a successful substitution of Ti4+ by S(4+) and/or S(6+), which caused a very small band-gap narrowing. The gel annealing in ammonia was much more efficient for interstitial nitrogen incorporation in TiO2 lattice than the powder annealing. The annealing in ammonia of the gel synthesized with dimethyl sulfoxide provided the highest visible-light activity owing to high specific surface area, appropriate mesoporosity and high photoabsorption due to efficient N,S co-doping. (C) 2016 Elsevier Ltd and Techna Group S.r.l. All rights reserved.
机译:通过非水解溶胶 - 凝胶途径合成可见光活性介孔N,S掺杂和共掺杂的锐钛矿TiO2粉末,从TiCl4和Ti((OPR)-PR-I)(4)溶解在环己烷或二甲基中亚砜,后来用作S掺杂剂。在惰性气氛中干燥后,将凝胶在500℃下退火3小时,在空气或氨流中,后来用于N-掺杂。通过在环己烷基凝胶的空气中退火获得的未掺杂的二氧化钛粉末也在氨中进行退火,以推导出哪种方法对N掺杂更有效:凝胶或粉末退火。在氨中退火后的空气中的后退火被优化以在模拟可见光下获得最佳的光催化活性以获得染料降解的最佳光催化活性。通过掺杂和粉末的比表面积增加,锐钛矿纳米晶体的尺寸增加。 XPS分析证实了Ti4 +的成功取代了S(4+)和/或S(6+),这导致了非常小的带间隙变窄。氨中的凝胶退火对于在TiO 2晶格中的间质氮掺入比粉末退火更有效。凝胶中的氨的退火为二甲基亚甲醚合成,由于高比表面积,由于高效的表面积,适当的中间孔隙度和高光吸收而提供了最高的可见光活性。 (c)2016 Elsevier Ltd和Techna Group S.R.L.版权所有。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号