...
首页> 外文期刊>Analog Integrated Circuits and Signal Processing >A 3 Gb/s transmitter with a tapless pre-emphasis CML output driver
【24h】

A 3 Gb/s transmitter with a tapless pre-emphasis CML output driver

机译:具有无抽头预加重CML输出驱动器的3 Gb / s发射机

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

A 3 Gb/s wireline transmitter (Tx) with a tap-less pre-emphasis current-mode logic output driver is presented in this paper. The proposed output driver can support 2.5, 6 and 10 dB pre-emphasis without any additional current tap. It can reduce the current consumption of the output driver by 30%. The 1.5 GHz phase-locked loop (PLL), multi-phase generator, and 26-to-1 serializer are utilized to serialize 26-bit parallel data to 1-bit 3 Gb/s serial data stream. The rms and peak-to-peak jitters of PLL are 2.97 and 22.5 ps, respectively. The eye opening of the proposed output driver at 3 Gb/s is 0.8UI with a 10 dB loss channel. The current consumption of the output driver is only 5.14 mA, and the Tx is 9 mA. The area of the Tx is 0.72 mm~2 using the 0.11 μm CMOS process.
机译:本文提出了一种具有无抽头预加重电流模式逻辑输出驱动器的3 Gb / s有线发射机(Tx)。建议的输出驱动器可以支持2.5、6和10 dB的预加重,而无需任何额外的电流抽头。它可以将输出驱动器的电流消耗降低30%。 1.5 GHz锁相环(PLL),多相发生器和26对1串行器用于将26位并行数据串行化为1位3 Gb / s串行数据流。 PLL的均方根值和峰峰值抖动分别为2.97和22.5 ps。建议的输出驱动器在3 Gb / s时的眼图张开率为0.8UI,具有10 dB的损耗通道。输出驱动器的电流消耗仅为5.14 mA,Tx为9 mA。使用0.11μmCMOS工艺,Tx的面积为0.72 mm〜2。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号