...
首页> 外文期刊>Journal of the Meteorological Society of Japan >Estimation of Direct Radiative Forcing of Asian Dust Aerosols with Sun/Sky Radiometer and Lidar Measurements at Gosan, Korea
【24h】

Estimation of Direct Radiative Forcing of Asian Dust Aerosols with Sun/Sky Radiometer and Lidar Measurements at Gosan, Korea

机译:韩国戈萨兰阳光/天空辐射计与亚洲粉尘气溶胶直接辐射强制估算

获取原文
获取原文并翻译 | 示例

摘要

In this study the aerosol direct radiative forcing (ADRF) of Asian dust is evaluated by model simulation at Gosan, Jeju using the data from a sun/sky radiometer, a Micro-Pulse Lidar (MPL), and column radiometer measurements of solar downwelling irradiance in April, 2001. We suggest a method of determining aerosol parameters for the radiative transfer model from the Aerosol Robotic Network (AERONET) data set. Since the AERONET measurements provide the refractive indices at only four wavelengths, and the aerosol parameters can be calculated at these wavelengths with a Mie code, we use a linear regression method for extending these measurements to the full wavelength spectrum of the radiative transfer model. The aerosol forcing by the Asian dust aerosols is estimated and compared to the aerosol forcing of non-dust aerosols. On the Asian dust event day, April 13, the daily average ADRF was estimated as -58.1 W/m~2 at the surface and -25.7 W/m~2 at the top of the atmosphere (TOA). On April 15, a non-dust day slightly influenced by anthropogenic aerosols, the ADRF was -29.0 W/m~2 at the surface and - 11.6 W/m~2 at the TOA. Although the Asian dust aerosols show larger forcing, its forcing efficiency (forcing per unit optical thickness) is smaller than that of non-dust aerosols; -41.0 W/m~2/τ_(670) at the TOA and -94.9 W/m~2/τ_(870) at the surface on the dust day for dust aerosols, as opposed to -50.0 W/m~2/τ_(670) at the TOA and -129.3 W/m~2/τ_(670) at the surface on the non-dust day for non-dust aerosols. We believe that this is due to the larger single scattering albedo of dust aerosols, which causes smaller absorption, and the larger asymmetry factor which causes more forward scattering or less reflection, compared to anthropogenic aerosols. The model results were validated with the surface irradiance measurement data and the comparison showed a good agreement. The radiative transfer calculation underestimates the solar irradiance of 2~3% on average. The aerosol profiles measured by lidar are used to estimate the influence of the vertical distribution of Asian dust aerosols on the ADRF. Using the vertical aerosol profiles, we found an instantaneous short wave radiative heating larger than 2 K/day. We believe the enhanced heating rate by the aerosol layers contributes to the increase in static stability within the dust layer. This fact is verified by the temperature profile measured by the sonde, and may explain the longevity and consequently long-range transport of Asian dust.
机译:在这项研究中,通过使用Sun / Sky辐射计,微脉冲LIDAR(MPL)和太阳能沉船辐照度的柱辐射计测量的数据,通过模型模拟,通过模型模拟来评估亚洲灰尘的气溶胶直接辐射强制(ADRF)。 2001年4月。我们建议一种从气溶胶机器人网络(AEROONET)数据集中确定辐射转移模型的气溶胶参数的方法。由于AERONET测量仅在仅四个波长下提供折射率,并且可以在这些波长用MIE码计算气溶胶参数,我们使用线性回归方法将这些测量扩展到辐射传输模型的全波长谱。估计亚洲粉尘气溶胶的气溶胶强制强迫,与非尘埃气溶胶的气溶胶强制进行比较。在亚洲尘埃日,4月13日,每日平均ADRF估计为-58.1W / m〜2,在大气顶部(TOA)顶部的-58.1W / m〜2。 4月15日,非粉尘日略有受到人为气溶胶的影响,ADRF在表面上为-29.0W / m〜2,TOA的11.6W / m〜2。虽然亚洲粉尘气溶胶显示出较大的强制性,但其强制效率(每单位光学厚度强制迫使)小于非尘埃气溶胶; -41.0 W /米〜2 /τ_(670)在所述TOA和-94.9 W /米〜2 /τ_(870)在上的灰尘一天灰尘气溶胶的表面上,而不是-50.0 W /米〜2 /在非尘埃气溶胶的非粉尘日的表面上的TOA和-129.3 W / m〜2 /τ_(670)的τ_(670)。我们认为这是由于粉尘气溶胶的单个散射反玻璃较大,这导致较小的吸收,并且与人为气溶胶相比导致较小的散射或较小的反射。模型结果用表面辐照度测量数据验证,比较显示了良好的一致性。辐射转移计算平均低估了太阳辐照度为2〜3%。 LIDAR测量的气溶胶谱用于估计亚洲粉尘气溶胶垂直分布对ADRF的影响。使用垂直气溶胶型材,我们发现瞬时短波辐射加热大于2 k /天。我们认为气溶胶层的增强的加热速率有助于灰尘层内的静态稳定性的增加。通过Sonde测量的温度曲线验证了这一事实,并且可以解释寿命和随后的亚洲灰尘的远程运输。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号