Mechanical Properties of Rubber Sheets Produced by Direct Molding of Ground Rubber Tire Powder

摘要

The so called "direct powder molding" is a compressions molding process which can be directly applied to ground rubber tire (GRT). This study shows that the GRT can be re-used to produce medium-size parts with good mechanical properties without any addition of virgin rubber. For rubber sheets prepared from the mechanically ground rubber tire (MGRT) and the cryogenically ground rubber tire (CGRT), the densities and crosslink densities of the rubber sheets increased with a decrease of the particle size of the waste tire powder. The tensile strength of the rubber sheets increased with the decreasing of the particle size for the two types of waste tire powder to 250 mu m and 120 mu m, respectively, and then became level. The moulding pressure had no effect on the densities, tensile strength or elongation at break of the rubber sheets. These results suggested that the effect of the particle size is important and is correlated with the mechanical properties of the rubber sheets produced by direct powder moulding technology. In general, the best mechanical properties were obtained with waste tire rubber with a size of about 250 mu m for the rubber particles obtained from the mechanical grinding method of waste tire powdering.