Effect of relative camber on the aerodynamic performance improvement of asymmetrical blunt trailing-edge modification

摘要

In this paper, the aerodynamic performance of the S series of wind turbine airfoils with different relative cambers and their modifications is numerically studied to facilitate a greater understanding of the effects of relative camber on the aerodynamic performance improvement of asymmetrical blunt trailing-edge modification. The mathematical expression of the blunt trailing-edge modification profile is established using the cubic spline function, and S812, S816 and S830 airfoils are modified to be asymmetrical blunt trailing-edge airfoils with different thicknesses. The prediction capabilities of two turbulence models, the k-omega SST model and the S-A model, are assessed. It is observed that the k-omega SST model predicts the lift and drag coefficients of S812 airfoil more accurately through comparison with experimental data. The best trailing-edge thickness and thickness distribution ratio are obtained by comparing the aerodynamic performance of the modifications with different trailing-edge thicknesses and distribution ratios. It is, furthermore, investigated that the aerodynamic performance of original airfoils and their modifications with the best thickness of 2% c and distribution ratio being 0:4 so as to analyze the increments of lift and drag coefficients and lift-drag ratio. Results indicate that with the increase of relative camber, there are relatively small differences in the lift coefficient increments of airfoils whose relative cambers are less than 1.81%, and the lift coefficient increment of airfoil with the relative camber more than 1.81% obviously decreases for the angle of attack less than 6.3A degrees. The drag coefficient increment of S830 airfoil is higher than that of S816 airfoil, and those of these two airfoils mainly decrease with the angle of attack. The average lift-drag ratio increment of S816 airfoil with the relative camber of 1.81% at different angles of attack ranging from 0.1A degrees to 20.2A degrees is the largest, closely followed by S812 airfoil. The lift-drag ratio increment of S830 airfoil is negative as the angle of attack exceeds 0.1A degrees. Thus, the airfoil with medium camber is more suited to the asymmetrical blunt trailing-edge modification.