首页> 外文期刊>Journal of Elastomers & Plastics >Blends of PS with SBR Devulcanized By Ultrasound:Rheology and Morphology
【24h】

Blends of PS with SBR Devulcanized By Ultrasound:Rheology and Morphology

机译:用超声波化的SBR融合PS:流变学和形态学

获取原文
获取原文并翻译 | 示例
           

摘要

The rheological properties and the morphology of blends of styrene-butadiene rubber (SBR),devulcanizated by ultrasound (dSBR),with polystyrene (PS) were studied.A compatibilizer,a styrene-butadiene block copolymer (SBS) was also added to dSBR/PS blends.The shear viscosity at low and high shear rates,the complex dynamic viscosity and the creep behavior were measured.It was observed that the addition of the dSBR to the PS caused little change in the shear viscosity at high shear rates,decreased the die swell and increased the elastic recovery.The analysis of the dSBR particles in blends after capillary rheometry showed that their shapes were extremely irregular with their sizes decreased and distribution narrowed with increase in the amount of dSBR and the shear rate.The addition of SBS to the blends was found to be more efficient on decreasing the dSBR particle size at the lowest concentration of dSBR.Depending on the dSBR concentration,the dSBR particle sizes in the blends varied between 18 and 6 mum.Thus in order to achieve a toughening of PS by an addition of dSBR,their particle size should be further reduced by changing the devulcanization process conditions.
机译:研究了通过聚苯乙烯(DSBR)的苯乙烯 - 丁二烯橡胶(SBR)混合物的流变性质和形态,用聚苯乙烯(PS),加入苯乙烯 - 丁二烯嵌段共聚物(SBS)中的苯乙烯 - 丁二烯嵌段共聚物(SBS)。 PS混合物。测量低剪切速率下的剪切粘度,复杂的动态粘度和蠕变行为。观察到DSBR向PS加入剪切率在高剪切速率下造成少量变化,降低了模具膨胀并增加弹性回收率。毛细管流变学后共混物中的DSBR颗粒的分析表明,它们的形状极其不规则,其尺寸降低和分布随着DSBR的量和剪切速率而变窄。添加SBS发现共混物在降低DSBR的最低浓度下降低DSBR粒度更有效。在DSBR浓度上,混合物中的DSBR颗粒尺寸变化EN 18和6 Mum.thus为了通过添加DSBR来实现PS的增韧,通过改变脱硫化工艺条件,应进一步降低它们的粒度。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号