A Dose-Response Study Examining the Use of Methacholine Challenge to Demonstrate Local Therapeutic Equivalence of the Salmeterol Component of Generic Inhaled Fluticasone Propionate/Salmeterol Combination Products

摘要

Background: Asthma is widely treated using inhaled corticosteroid/long-acting beta agonist (LABA) combinations, for example, fluticasone propionate/salmeterol (FPS) dry powder inhaler, marketed as Advair? Diskus?. Some regulators require generics to demonstrate local (lung) therapeutic equivalence (LTE) for each component of the FPS reference, ideally with a dose-response within the approved FPS dose range. We sought to develop a methacholine challenge (MeCh) LTE methodology for assessing the LABA (salmeterol) component of FPS.Methods: Forty-six patients with asthma received single doses of albuterol (active control; 90 or 180?μg), FPS (100/50 or 200/100?μg), and placebo on 5 separate study days. Spirometry and MeCh were performed 1, 6, and 10 hours after study drug inhalation. Primary endpoint was provocative concentration of methacholine producing a 20% fall in forced expiratory volume in 1 second (PC20). Study entry required screening PC20 ≤8?mg/mL, with a greater than fourfold increase (and PC20 ≤128?mg/mL) after 180?μg albuterol.Results: Both albuterol (90 and 180?μg) and FPS (100/50 and 200/100?μg) significantly increased PC20 compared with placebo (sustained 6 and 10 hours postdose with FPS but not albuterol). The dose-response slopes (95% confidence interval) estimated 1 hour after treatment were 0.374 (?0.068 to 0.815) and 0.310 (?0.135 to 0.754) between low and high doses of albuterol and FPS, respectively, both nonsignificant. Slopes were shallower than those available in the literature for albuterol and formoterol, but similar to those for salmeterol.Conclusions: These data confirm that the bronchoprotective effect of FPS lasts longer than that of albuterol. The shallow dose-response slope we observed for albuterol is contrary to previous reports, probably due to the measurement of PC20 beginning at 1 hour postdose. The results suggest that use of MeCh to assess LTE for salmeterol formulations may be more difficult to accomplish than it is for albuterol and formoterol products.