首页> 外文期刊>Pure and Applied Geophysics >Ultrasonic P- and S-Wave Attenuation and Petrophysical Properties of Deccan Flood Basalts, India, as Revealed by Borehole Studies
【24h】

Ultrasonic P- and S-Wave Attenuation and Petrophysical Properties of Deccan Flood Basalts, India, as Revealed by Borehole Studies

机译:钻孔研究揭示了甲板洪水沼泽的超声波和S波衰减和岩石物理特性,如钻孔研究所透露

获取原文
获取原文并翻译 | 示例
           

摘要

Petrophysical properties and ultrasonic P- and S-wave attenuation measurements on 35 Deccan basalt core specimens, recovered from Killari borehole site in western India, provide unique reference data-sets for a lesser studied Deccan Volcanic Province. These samples represent 338-m-thick basaltic column, consisting four lava flows each of Ambenali and Poladpur Formations, belonging to Wai Subgroup of the Deccan volcanic sequence. These basalt samples are found to be iron-rich (average FeOT: 13.4 wt%), but relatively poor in silica content (average SiO2: 47.8 wt%). The saturated massive basalt cores are characterized by a mean density of 2.91 g/cm(3) (range 2.80-3.01 g/cm(3)) and mean P- and S-wave velocities of 5.89 km/s (range 5.01-6.50 km/s) and 3.43 km/s (range 2.84-3.69 km/s), respectively. In comparison, saturated vesicular basalt cores show a wide range in density (2.40-2.79 g/cm(3)) as well as P-wave (3.28-4.78 km/s) and S-wave (1.70-2.95 km/s) velocities. Based on the present study, the Deccan volcanic sequence can be assigned a weighted mean density of 2.74 g/cm(3) and a low V (p) and V (s) of 5.00 and 3.00 km/s, respectively. Such low velocities in Deccan basalts can be attributed mainly to the presence of fine-grained glassy material, high iron contents, and hydrothermally altered secondary mineral products, besides higher porosity in vesicular samples. The measured Q values in saturated massive basalt cores vary enormously (Q (p): 33-1960 and Q (s): 35-506), while saturated vesicular basalt samples exhibit somewhat lesser variation in Q (p) (6-46) as well as Q (s) (5-49). In general, high-porosity rocks exhibit high attenuation, but we observed the high value of attenuation in some of the massive basalt core samples also. In such cases, energy loss is mainly due to the presence of fine-grained glassy material as well as secondary alteration products like chlorophaeite, that could contribute to intrinsic attenuation. Dominance of weekly bound secondary min
机译:岩石物理学和超声波和S波衰减测量在印度西部碱基钻孔场所回收的35张Deccan玄武岩核心标本,为较小的Deccan火山省提供独特的参考数据集。这些样品代表338米厚的玄武岩柱,包括四个熔岩流,每个Ambenali和Poladpur地层都属于Deccan火山序列的Wai子组。这些玄武岩样品被发现是富含铁(平均电景:13.4wt%),但二氧化硅含量相对较差(平均SiO 2:47.8wt%)。饱和大规模玄武岩芯的特征在于平均密度为2.91g / cm(3)(范围2.80-3.01g / cm(3)),平均p&s波速度为5.89 km / s(范围5.01-6.50 KM / s)和3.43 km / s(范围2.84-3.69 km / s)。相比之下,饱和的囊泡玄武岩芯的密度宽范围(2.40-2.79g / cm(3))以及P波(3.28-4.78km / s)和S波(1.70-2.95 km / s)速度。基于本研究,脱碳火山序列可以分配2.74g / cm(3)的加权平均密度,分别为5.00和3.00 km / s的低V(p)和v(p)。除了温度较高的孔隙率在凹凸样品中,这种低型底座的低速可归因于细粒玻璃材料,高铁内容和水热改变的二次矿物产品。饱和大规模玄武岩芯中的测量Q值变化很大(Q(P):33-1960和Q(S):35-506),而饱和的囊泡玄武岩样品在Q(P)(6-46)中表现出稍微较小的变化(6-46)以及Q(s)(5-49)。一般来说,高孔隙率岩石表现出高衰减,但我们在一些大型玄武岩核心样品中观察到高衰减值。在这种情况下,能量损失主要是由于薄粒玻璃材料的存在以及叶绿素等二次改变产物,这可能有助于内在衰减。每周约束中学的统治

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号