【24h】

Moment rate of the 2018 Gulf of Alaska earthquake

机译:阿拉斯加地震2018年海湾的时刻率

获取原文
获取原文并翻译 | 示例
           

摘要

The 2018 Gulf of Alaska earthquake (Mw 7.9) occurred in a region of the Pacific plate southwest of the Alaskan subduction zone. The earthquake was a strike-slip event, with the hypocenter located at a depth of about 25 km and a seismic moment equal to 0.96 x 10(21) Nm. Two observed moment rates have been obtained by the Geoscope Observatory, France, and by the United States Geological Survey (USGS). Both of them can be interpreted as due to the failure of two asperities on the fault surface. We consider a discrete fault model, with two asperities of different areas and strengths, and show that the observed moment rates can be reproduced by appropriate values of the model parameters, as inferred from the available data. A good fit to the observed moment rates is obtained by a sequence of three dynamic modes of the system, including a phase of simultaneous slip of the asperities. The two moment rates are however characterized by different initial conditions, in terms of different initial shear stress distributions on the fault. Shear stresses on the asperities are calculated as functions of time during the event and show a similar evolution in the two cases, but with different final values. The model results show that the presence of simultaneous asperity motion can significantly increase the seismic moment of a large earthquake.
机译:2018年的阿拉斯加地震(MW 7.9)发生在阿拉斯加郊区西南地区的一个地区。地震是一个罢工杂志,斜视位于约25 km的深度,地震时刻等于0.96×10(21)nm。从地腔观测站,法国和美国地质调查(USGS)获得了两个观察到的矩速率。它们都可以解释为由于故障表面上的两个粗糙度的故障而被解释为。我们考虑了一个离散的故障模型,具有不同区域和强度的两个粗糙度,并且表明观察到的矩速率可以通过可用数据推断出模型参数的适当值来再现。通过系统的三种动态模式的序列获得了良好的拟合,该序列是由系统的三种动态模式获得的,包括同时滑动粗糙度的相位。然而,在故障上的不同剪切应力分布方面,两个时刻的速率是不同的初始条件。抑制粗糙度的剪切应力作为事件期间的时间的函数计算,并在两种情况下显示出类似的演变,但具有不同的最终值。模型结果表明,同时粗糙运动的存在可以显着增加大地震的地震时刻。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号