...
首页> 外文期刊>Silicon >Optical Properties of Silver Halide Photochromic Glasses Doped with Cobalt Oxide
【24h】

Optical Properties of Silver Halide Photochromic Glasses Doped with Cobalt Oxide

机译:掺杂钴氧化钴的卤化银光致变色玻璃的光学性质

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Photochromic glasses having composition (SiO2)(45)(B2O3)(35)(Al2O3)(7.5)(Na2O)(12.5)(AgBr), (Cu2O) doped with (CoO)(x) , in which, x = 0, 0.006, 0.02 and 0.07 g were prepared using the conventional melt technique. The amorphous nature of these glass samples was confirmed using X-ray diffraction analysis at room temperature. The absorption measurements in the infrared region of the spectrum were recorded in the wave number range (4000-400) cm(-1). Spectral reflectance and transmittance at normal incidence of the prepared glass samples were recorded with a spectrophotometer in the spectral range 200-2500 nm. Experimental and theoretical densities of the prepared glass samples were measured, calculated and compared. Analytical expressions were used to calculate the real and imaginary parts of the refractive indices. Dispersion parameters such as: single oscillator energy, dispersion energy, average oscillator wavelength, and Abbe's number were deduced and compared. Absorption dispersion parameters such as: optical energy gap for direct and indirect transitions, Urbach energy and steepness parameter were calculated. Effects of doping with cobalt oxide CoO as a transition metal on linear and predicted nonlinear optical parameters were investigated and interpreted. Experimental results indicate that there is an optimum concentration of cobalt doping around 0.006 g. The optical band gap decreases with increasing doping and causes an increase in nonlinear optical parameters. Doping with cobalt oxide improves the linear and nonlinear optical properties of the prepared glasses.
机译:具有组合物(SiO 2)(45)(B2O3)(35)(Al 2 O 3)(7.5)(Na 2 O)(12.5)(Agbr),(Cu 2 O)的光致变色镜(Al 2 O 3)(Ag2O),其中,其中x = 0使用常规熔体技术制备0.006,0.02和0.07g。使用X射线衍射分析在室温下确认这些玻璃样品的无定形性质。光谱的红外区域中的吸收测量记录在波数范围(4000-400)cm(-1)中。用分光光度计在200-2500nm的光学光度计中记录在正常入射率时的光谱反射率和透射率。测量制备玻璃样品的实验和理论密度,计算并进行比较。分析表达式用于计算折射率的真实和虚部。分散参数如:单振荡能量,色散能量,平均振荡器波长和ABBE的数量进行了比较。诸如:计算出用于直接和间接转变的光学能隙,URBACH能量和陡度参数的吸收分散参数。研究了掺杂钴氧化物COO作为线性和预测非线性光学参数的过渡金属的影响。实验结果表明,掺杂约0.006g的最佳浓度浓度。光带间隙随着掺杂的增加而降低,并导致非线性光学参数的增加。掺杂氧化钴改善了制备玻璃的线性和非线性光学性质。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号