首页> 外文期刊>Radiation measurements >Neutron spectral fluence and dose distribution inside a NYLON 6 phantom irradiated with pencil beam of high energy protons
【24h】

Neutron spectral fluence and dose distribution inside a NYLON 6 phantom irradiated with pencil beam of high energy protons

机译:中子光谱注入尼龙6幻影内的尼龙6幻灯片的剂量分布

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Monte Carlo (MC) simulations using the MCNPX (TM) code supported by measurements were exploited for detailed characterization of secondary neutrons generated by high energy protons during pencil beam proton therapy. The study focused on the estimation of the distribution of secondary neutron points of origin, their average initial energy, and the distribution of absorbed dose and equivalent dose from neutrons and photons inside the NYLON 6 phantom (diameter of 25.5 cm, length of 31.0 cm) irradiated with a proton beam with the energies of 100, 150 and 200 MeV. Validation of the MC model and the used methods was done by comparison of calculated responses of the extended-range Bonner Sphere Spectrometer at several positions outside the phantom with the measured ones. The results show that high energy neutrons predominate in the direction of the proton beam and more neutrons are generated by higher energy protons. The MC simulations also demonstrated that the majority of high energy neutrons is generated at the beginning of the proton trajectory in the phantom and the neutron yield and neutron initial average energy decrease with increasing depth. Therefore, attention should be paid not only to the tissues behind the irradiated volume, but also to the preceding ones. However, the neutron spectral fluence in the vicinity of the treated tissue can only be determined by calculation, mainly due to the dimensions of the neutron spectroscopic instrumentation.
机译:使用测量支持的MCNPX(TM)代码的Monte Carlo(MC)模拟被利用用于在铅笔束质子疗法期间由高能质子产生的二级中子进行详细表征。该研究专注于估计中子中子点的分布,其平均初始能量,以及尼龙6幻像内的中子和光子的吸收剂量和相同剂量的分布(直径为25.5cm,长度为31.0cm)用质子束照射,具有100,150和200芒的能量。通过比较延伸范围棕质球体光谱仪在近几个位置的若干位置的计算响应来验证MC模型和使用的方法。结果表明,高能量中子在质子梁的方向上占主导地位,并且通过更高的能量质子产生更多中子。 MC模拟还证明了大部分高能量中子在体模的质子轨迹的开始时产生,中子产量和中子率初始能量随着深度的增加而降低。因此,应注意不仅应支付给照射体积背后的组织,也应给前面的组织支付。然而,在处理的组织附近的中子谱注入只能通过计算确定,主要是由于中子谱仪仪器的尺寸。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号