Fine-scale structural features of intercritically aged HSLA-100 plate steel and their influence on yield strength and low-temperature impact toughness

摘要

Fine-scale structural features of an HSLA-100 steel intercritically aged at 950 K (677 degrees C) for 4.2 ks (70 min.) were investigated via transmission electron microscopy. The microstructure consisted of approximately 90 vol. pct. of low-carbon lath martensite. Average lath width was about 0.25 mu m, unchanged from the as-quenched condition, owing to a high number density of epsilon-copper precipitates at these boundaries. About 10 vol. pct. of medium-carbon austenite existed as coarsened, broken-up islands between laths; martensite lath boundary coverage by austenite was notably reduced compared to the as-quenched condition. Greater continuity between adjacent low-carbon martensite laths was accompanied by coarse copper precipitates within laths and an order of magnitude lower dislocation density than the as-quenched martensite. Collectively, these features produced a sub-grain coarsening effect. Austenite islands larger than about 0.5 mu m were unstable with respect to the formation of fresh, medium-carbon martensite regions. Copper precipitation within austenite islands (owing to carbon and copper enrichment) might also have contributed to austenite transformation upon quenching. Intercritical aging was associated with a strong-and-undesirable deviation from strength-toughness behavior at sub-critical aging temperatures. Two key factors were identified as being responsible for this negative outcome: (i) a sub-grain coarsening effect associated with "delamellarization" of low-carbon martensite and austenite and (ii) the formation of brittle martensite upon quenching. Quantitative estimates of the changes in strength and impact toughness are provided for microstructural differences between intercritically aged and subcritically aged material.