...
首页> 外文期刊>Acta odontologica Scandinavica. >Impact of remineralizing agents on enamel microhardness recovery after in-office tooth bleaching therapies
【24h】

Impact of remineralizing agents on enamel microhardness recovery after in-office tooth bleaching therapies

机译:再矿化剂对办公室牙齿漂白治疗后牙釉质显微硬度恢复的影响

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Objective. It has been shown that bleaching with 35/38% hydrogen peroxides may alter both enamel morphology and mineral content. This study aimed to analyze the morphology and microhardness of enamel bleached with in-office hydrogen peroxides and exposed toremineralizing agents. Materials and methods. After recording initial enamel morphology and microhardness, 60 bovine incisors were bleached using either a calcium-containing 35% hydrogen peroxide (Whiteness HP Blue) or a calcium-free 35% hydrogen peroxide (Whitegold Office) (n = 30). Then, the teeth were subjected to one of three post-bleaching remineralizing treatments (n = 10): storage in artificial saliva only, application of a sodium fluoride gel or application of a nanohydroxyapatite-based agent (Nano-P). After 24 h and 14 days of post-bleaching treatments, the enamel morphology and microhardness were re-evaluated. The microhardness data were analyzed by means of two-way ANOVA with repeated measurements and Tukey tests (p < 0.05), while the enamel morphology was analyzed descriptively. Results. Samples exposed to Nano-P presented statistically the highest microhardness 24 h after its application in comparison with other remineralizing agents. The microhardness recovery did not occur in any of the groups 14 days after treatment. The morphology of all samples 14 days after the application of all remineralizing agents presented a higher number of irregularities. Conclusion. Although some remineralizing products provided microhardness recovery and a positive effect on enamel morphology at 24 h post-bleaching, none of them were able to maintain microhardness and enamel morphology at 14 days post-bleaching.
机译:目的。已经表明用35/38%的过氧化氢漂白可以改变釉质形态和矿物质含量。这项研究旨在分析用办公室过氧化氢和暴露于再矿化剂漂白的搪瓷的形态和显微硬度。材料和方法。记录牙釉质的初始形态和显微硬度后,使用含钙35%的过氧化氢(Whiteness HP Blue)或无钙35%的过氧化氢(Whitegold Office)(n = 30)对60个牛切牙进行漂白。然后,对牙齿进行三种漂白后再矿化处理(n = 10)之一:仅在人造唾液中存储,应用氟化钠凝胶或使用基于纳米羟基磷灰石的试剂(Nano-P)。漂白后24小时和14天后,重新评估了牙釉质的形态和显微硬度。通过两次重复测量和Tukey测试(p <0.05)的双向ANOVA分析显微硬度数据,同时描述性地分析牙釉质形态。结果。与其他矿化剂相比,暴露于Nano-P的样品在施涂24小时后具有最高的显微硬度。治疗后14天,任何一组均未发生显微硬度恢复。在使用所有矿化剂后14天,所有样品的形态均出现大量不规则现象。结论。尽管一些再矿化产品在漂白后24小时提供了显微硬度恢复并对牙釉质形态产生了积极影响,但它们均无法在漂白后14天保持显微硬度和釉质形态。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号