首页> 外文期刊>Bulletin of Materials Science >Precipitate coarsening parameters for gas induced semi-solid cast 7075-T6 Al alloy determined by SAXS measurements
【24h】

Precipitate coarsening parameters for gas induced semi-solid cast 7075-T6 Al alloy determined by SAXS measurements

机译:通过SAXS测量确定气体诱导的气体诱导的半固体铸造7075-T6 Al合金沉淀粗化参数

获取原文
获取原文并翻译 | 示例
           

摘要

The particle radii of precipitates in the gas induced semi-solid (GISS) cast 7075-T6 Al alloys, for ageing times ranging from peak ageing to over ageing, were measured by small-angle X-ray scattering (SAXS) technique. The measured precipitate radii increased with ageing time and temperature, and data were well fit by the Lifshitz-Slyozov-Wagner (LSW) coarsening process along with a modified Arrhenius equation for temperature dependency. The activation energy for the coarsening process was estimated at 1.19 eV, which is close to that of the wrought 7075 Al alloy. This energy is in the range of activation energies of Zn, Mg and Cu for their diffusion in Al. The precipitate coarsening rate of this alloy appears to be diffusion limited. The fine precipitates of the GISS 7075-PA Al alloy coarsened slowly at 63 nm(3) h(-1) rate, at the elevated 200 degrees C temperature, while rapid 216 nm(3) h(-1) coarsening was found in the wrought 7075-T651 Al alloy.
机译:通过小角X射线散射(SAXS)技术测量,气体诱导的半固体(GISS)浇注的半固体(GISS)铸造7075-T6 Al合金中沉淀物中的沉淀物,用于从峰值老化到过度老化。 测量的沉淀物半径随着老化时间和温度而增加,并且通过Lifshitz-Slyozov-Wagner(LSW)粗化过程以及改进的Arhenius方程进行了良好的温度依赖性。 粗化工艺的激活能量估计在1.19eV,其接近锻造7075铝合金的EV。 这种能量在Zn,Mg和Cu的激活能量范围内,在Al中的扩散。 该合金的沉淀粗化速率似乎是扩散有限的。 姜7075-pa的细沉淀物在63nm(3)小时(-1)速率下,在升高的200℃温度下粗略地粗糙,同时发现快速216nm(3)小时(3)小时(-1)粗化 锻造了7075-T651 Al合金。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号