...
首页> 外文期刊>Desalination: The International Journal on the Science and Technology of Desalting and Water Purification >Cost-based feasibility study and sensitivity analysis of a new draw solution assisted reverse osmosis (DSARO) process for seawater desalination
【24h】

Cost-based feasibility study and sensitivity analysis of a new draw solution assisted reverse osmosis (DSARO) process for seawater desalination

机译:新型绘制解决方案的基于成本的可行性研究和敏感性分析辅助反渗透(Dsaro)海水淡化过程

获取原文
获取原文并翻译 | 示例
           

摘要

In this study, a newly devised seawater desalination process, namely, the draw solution assisted reverse osmosis (DSARO) process, is proposed. A mathematical model for the DSARO process was developed and energy consumption and economic evaluation models were constructed to assess the feasibility of the DSARO process compared to the conventional reverse osmosis (RO) process. This work presents a characterization of important variables and the research on the effects of these variables. Compared to the conventional RO process, the DSARO process could have a 10% lower specific water production cost. The operating pressures required to reach 40% of overall recovery were approximately 35 bar in the 1st RO process, and 30 bar in the 2nd RO process. Due to its operating pressure being lower than the conventional RO process, the capital and membrane replacement costs could be reduced. The required conditions in the 1st RO membrane to drive the DSARO process were that the membrane structure parameter must be lower than 0.13 mm, and the maximum operating pressure should be higher than 35 bar. Even though these conditions are not available commercially at present, they could be attained based on the best available membrane technology in the literature.
机译:在这项研究中,提出了一种新设计的海水淡化过程,即提出了汲取溶液辅助反渗透(Dsaro)过程。开发了一种用于DSARO过程的数学模型,构建了能耗和经济评估模型,以评估与传统反渗透(RO)过程相比的DSARO过程的可行性。这项工作提出了重要变量的表征和对这些变量影响的研究。与传统的RO过程相比,DSARO过程可具有10%的特定水生产成本。达到40%的整体回收所需的操作压力在第一RO过程中约为35巴,第二个RO工艺30巴。由于其运行压力低于传统的RO过程,可以降低资本和膜更换成本。第1 ro膜中的所需条件以驱动DSARO工艺的是膜结构参数必须低于0.13毫米,最大工作压力应高于35巴。尽管目前这些条件不可用,但它们可以基于文献中最佳可用膜技术实现。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号