首页> 外文期刊>Journal of chromatography, A: Including electrophoresis and other separation methods >Use of microextraction by packed sorbents following selective pressurised liquid extraction for the determination of brominated diphenyl ethers in sewage sludge by gas chromatography-mass spectrometry
【24h】

Use of microextraction by packed sorbents following selective pressurised liquid extraction for the determination of brominated diphenyl ethers in sewage sludge by gas chromatography-mass spectrometry

机译:选择性加压液体萃取后填充吸附剂的微萃取用于气相色谱-质谱法测定污水污泥中的溴化二苯醚

获取原文
获取原文并翻译 | 示例
           

摘要

In this work, a method based on selective pressurised liquid extraction followed by microextraction by packed sorbents (MEPS) for the determination of brominated diphenyl ethers (BDEs) in sewage sludge is presented. The factors affecting the MEPS procedure were optimised. Acetone:water (25:75) sPLE extracts were drawn-ejected 10 times through C18 cartridges at 5 μL s~(-1). The cartridge was dried five times with 250 μL of air and the BDEs were eluted at 25 μL s~(-1) with 100 μL of n-hexane that were directly injected at 13 μL s-1 in the GC-MSMS system. Under these conditions, there were no carry-over effects. The method was characterised in terms of limits of detection, repeatability, intermediate precision and accuracy. The use of MEPS for the determination of BDEs in sewage sludge means an improvement of the limits of detection due to the preconcentration and clean-up performed before the injection of the whole elute in the PTV injector. The GC-MSMS LODs (25 pg mL-1) were improved with MEPS to less than 3 pg mL-1. RSD less than 7% and recovery values from 92% to 102% were shown. Finally, the method was applied to the sPLE extract analyses of sewage sludge from several wastewater treatment plants in La Rioja. To our knowledge, this is the first time that the MEPS technique has been applied to the analysis of BDEs, and the first time that it has been used for the analysis of extracts from a solid sample.
机译:在这项工作中,提出了一种方法,该方法基于选择性加压液体萃取,然后用填充吸附剂(MEPS)微萃取,用于测定污水污泥中的溴化二苯醚(BDE)。对影响MEPS程序的因素进行了优化。将丙酮:水(25:75)sPLE提取物以5μLs〜(-1)通过C18小柱抽提10次。将柱子用250μL空气干燥五次,然后用25μLs〜(-1)用100μL正己烷洗脱BDE,然后将其直接以13μLs-1注入GC-MSMS系统。在这些条件下,没有残留效应。根据检测限,可重复性,中间精度和准确性对方法进行了表征。使用MEPS测定污水污泥中的BDE意味着,由于在PTV进样器中注入全部洗脱液之前进行了预浓缩和净化,从而提高了检测限。用MEPS将GC-MSMS LOD(25 pg mL-1)改善至小于3 pg mL-1。显示RSD小于7%,回收率从92%到102%。最后,该方法用于从La Rioja的几家污水处理厂提取污水污泥的sPLE提取物。据我们所知,这是首次将MEPS技术用于BDE的分析,并且首次将其用于分析固体样品中的提取物。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号