首页> 外文期刊>Dalton transactions: An international journal of inorganic chemistry >The effect of the synthetic route on the structural, textural, morphological and catalytic properties of iron(III) oxides and oxyhydroxides
【24h】

The effect of the synthetic route on the structural, textural, morphological and catalytic properties of iron(III) oxides and oxyhydroxides

机译:合成路线对三价铁氧化物和羟基氧化物的结构,组织,形态和催化性能的影响

获取原文
获取原文并翻译 | 示例
           

摘要

A variety of iron(iii) oxides and oxyhydroxides were synthesised and characterised using three distinct methods of preparation: microemulsion, precipitation and sot-gel. The results clearly showed that the structure, textural properties, crystal morphology and catalytic performance of the phases obtained were highly dependent on the chemical routes used for the synthesis. Precipitation and microemulsion methods allowed obtaining mesoporous nanostructured iron(III) oxides with mean particle sizes of 4 nm (amorphous hematite) and 7 nm (ferrihydrite), which exhibited a high surface area (291.4 m(2) g(-1) and 192.3 m(2) g(-1), respectively) and a very good catalytic behaviour in the advanced oxidation of highly non biodegradable wastewaters. The different conditions employed in the synthesis of these materials through the sot-gel method yielded two goethites with practically the same catalytic properties, but dissimilar morphologies and texture. When soft agitation and slow addition of the precipitating agent were used, the resulting material (G1) was made up of shorter and finer particles, markedly acicutar, with an average length of 400 +/- 50 nm and width of 15 +/- 5 nm. However, vigorous agitation and rapid addition of the precipitating agent led to the formation of longer and coarser particles, moderately acicular, the average length and width being 950 +/- 100 nm and 140 +/- 20 nm, respectively. The use of the sot-gel technique also resulted in the formation of a solid consisting of a mixture of hematite as the main crystalline phase and goethite particles dispersed among the hematite particles. This solid presented a low specific surface area (13.2 m(2) g(-1)) and lower catalytic activity. Therefore, precipitation and microemulsion proved to be the most suitable techniques to synthesise catalytically active disordered iron(III) oxide nanoparticles, due to the presence of highly reactive non-stoichiometric iron(III) ions, a higher surface area and smaller particle sizes.
机译:使用三种不同的制备方法合成并表征了多种氧化铁和氢氧化氢氧化物:微乳液,沉淀和胶体凝胶。结果清楚地表明,所得相的结构,结构性质,晶体形态和催化性能高度依赖于用于合成的化学路线。沉淀和微乳化方法允许获得平均粒径为4 nm(无定形赤铁矿)和7 nm(三水铁矿)的介孔纳米结构铁(III)氧化物,该氧化物具有高表面积(291.4 m(2)g(-1)和192.3) m(2)g(-1)分别)和高度不可生物降解废水的高级氧化中非常好的催化行为。通过sot-gel方法合成这些材料所采用的不同条件产生了两种针铁矿,它们实际上具有相同的催化性能,但形态和质地却不同。当使用软搅拌和缓慢添加沉淀剂时,所得材料(G1)由较短和较细的颗粒组成,明显为针形,平均长度为400 +/- 50 nm,宽度为15 +/- 5纳米然而,剧烈搅拌和快速添加沉淀剂导致形成较长和较粗的,中等针状的颗粒,平均长度和宽度分别为950 +/- 100nm和140 +/- 20nm。使用软凝胶技术还导致形成固体,该固体由作为主要结晶相的赤铁矿和分散在赤铁矿颗粒之间的针铁矿颗粒的混合物组成。该固体具有较低的比表面积(13.2 m(2)g(-1))和较低的催化活性。因此,由于存在高反应性非化学计量的铁(III)离子,较高的表面积和较小的粒径,沉淀和微乳液被证明是最适合合成催化活性无序氧化铁(III)纳米颗粒的技术。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号