...
首页> 外文期刊>Talanta: The International Journal of Pure and Applied Analytical Chemistry >Development of a wet digestion method for paints for the determination of metals and metalloids using inductively coupled plasma optical emission spectrometry
【24h】

Development of a wet digestion method for paints for the determination of metals and metalloids using inductively coupled plasma optical emission spectrometry

机译:用电感耦合等离子体发射光谱法测定涂料中金属和准金属的湿消解方法

获取原文
获取原文并翻译 | 示例
           

摘要

Paints, a complex matrix, have a variable composition that is dependent on the application. In this work, a new wet digestion procedure for the determination of Al, As, Ba, Cd, Cr, Cu, Mn, Ni, Pb, Sn, Sr, Ti and Zn in paint samples using inductively coupled plasma optical emission spectrometry (ICP OES) has been developed. An experimental design approach was employed to determine the optimal conditions for achieving complete solubilization and/or decomposition in the sample preparation method. An efficient sample preparation was developed that consisted of a pre-digestion step at 40 degrees C for 20 min using 1 mL of HNO3 to eliminate organic solvents followed by digestion at 120 degrees C for 3 h using 5 mL of HCl and 1 mL of HF in a block digestion. The proposed procedure promotes the complete solubilization of different bases of paints at low temperature and atmospheric pressure. The accuracy was determined by addition/recovery tests and comparing the results with those obtained using the ASTM D335-85a standard sample preparation method. The limits of quantification were 1.78, 0.11, 0.006, 0.006, 0.01, 0.04, 0.006, 0.006, 0.02, 0.07, 0.30, 1.30 and 030 mg kg(-1) for Al, As, Ba, Cd, Cr, Cu,Mn, Ni, Pb, Sn, Sr, Ti and Zn, respectively. The proposed method was applied for the analysis of inorganics via the ICP OES of paints with different colors and bases used to cover wall surfaces. (C) 2015 Elsevier B.V. All rights reserved.
机译:涂料是一种复杂的基质,其成分取决于应用场合。在这项工作中,采用电感耦合等离子体光发射光谱法(ICP)测定涂料样品中的Al,As,Ba,Cd,Cr,Cu,Mn,Ni,Pb,Sn,Sr,Ti和Zn的新的湿消解程序OES)已开发。实验设计方法用于确定在样品制备方法中实现完全溶解和/或分解的最佳条件。开发了一种有效的样品制备方法,包括在40摄氏度下使用1毫升HNO3进行20分钟的消解步骤,以消除有机溶剂,然后在120摄氏度下使用5毫升HCl和1毫升HF消化3小时。在块消化中。所提出的方法促进了在低温和大气压下不同基础涂料的完全溶解。通过添加/回收测试并将结果与​​使用ASTM D335-85a标准样品制备方法获得的结果进行比较,来确定准确性。 Al,As,Ba,Cd,Cr,Cu,Mn的定量限为1.78、0.11、0.006、0.006、0.01、0.04、0.006、0.006、0.02、0.07、0.30、1.30和030 mg kg(-1)分别为Ni,Pb,Sn,Sr,Ti和Zn。所提出的方法通过ICP OES用于具有不同颜色和用于覆盖墙壁表面的基础涂料的ICP OES分析。 (C)2015 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号