首页> 外文期刊>Talanta: The International Journal of Pure and Applied Analytical Chemistry >Electrochemical generation of antimony volatile species, stibine, using gold and silver mercury amalgamated cathodes and determination of Sb by flame atomic absorption spectrometry
【24h】

Electrochemical generation of antimony volatile species, stibine, using gold and silver mercury amalgamated cathodes and determination of Sb by flame atomic absorption spectrometry

机译:使用金和银汞齐混合阴极电化学生成锑挥发性物质,锑代碱,并通过火焰原子吸收光谱法测定锑

获取原文
获取原文并翻译 | 示例
           

摘要

The electrochemical generation of antimony volatile species (stibine) using Au and Ag mercury amalgamated cathodes is described. Compared with some other cathode materials commonly used for electrochemical hydride generation, performance of the amalgamated cathodes is substantially better in the following aspects: higher interference tolerance, higher erosion resistance and longer useful working time. Using the amalgamated cathodes, it could be shown that interferences from major constituents at high concentrations, especially from transition metals, affecting stibine generation are not as significant as they are using other cathode types in regards to sensitivity and useful working time. Results obtained using the Ag/Hg amalgamated cathode showed a slightly higher sensitivity than the corresponding results obtained using the Au/Hg cathode. The Au/Hg cathode, which to our knowledge has not previously been used to generate stibine, showed considerably longer useful working time than the Ag/Hg one. The optimum catholytes for electrolytic generation of stibine (SbH3) from Sb(III) and Sb(V) using the Au/Hg electrode were aqueous solutions containing 0.5 mol L-1 H2SO4 and 0.5 mol L-1HCl, respectively. Under optimized conditions, using the Au/Hg cathode and comparing to aqueous standards calibration curves, detection limits (3 sigma) of 0.027 mu g L-1 for Sb(III) and 0.056 mu g L-1 for Sb(V), were obtained. To check accuracy a marine sediment reference material (PACS-2, NRC) was analyzed using a method purportedly developed for this task. Good agreement, 95% confidence, was found between the certified and the experimental values for Sb. The proposed method was also applied to the determination of Sb in aqueous solutions of marine sediments samples from Comuna de Bajo Alto Provincia de El Oro Ecuador. Recoveries of five replicate determinations of these samples were in the range of 98-103% thus showing acceptable accuracy in the analysis of real samples. (C) 2015 Elsevier B.V. All rights reserved.
机译:描述了使用金和银汞齐化阴极电化学生成锑挥发性物质(锑)。与通常用于产生电化学氢化物的某些其他阴极材料相比,汞齐化阴极的性能在以下方面显着更好:更高的耐干扰性,更高的耐腐蚀性和更长的工作时间。使用合并的阴极,可以证明,在灵敏度和有用的工作时间方面,来自高浓度主要成分(尤其是过渡金属)的影响,影响碱金属生成的干扰并不像使用其他阴极类型时那么重要。使用Ag / Hg混合阴极获得的结果显示出比使用Au / Hg阴极获得的相应结果稍高的灵敏度。据我们所知,Au / Hg阴极以前没有被用来产生锑化氢,显示出比Ag / Hg阴极更长的有用工作时间。使用Au / Hg电极从Sb(III)和Sb(V)电解生成锑(SbH3)的最佳阴极电解液分别是含有0.5 mol L-1 H2SO4和0.5 mol L-1HCl的水溶液。在优化条件下,使用Au / Hg阴极并与水标准校准曲线进行比较,Sb(III)的检出限(3 sigma)为0.027μg L-1,Sb(V)的检出限为0.056μg L-1获得。为了检查准确性,使用了据称为此任务开发的方法对海洋沉积物参考材料(PACS-2,NRC)进行了分析。在Sb的认证值和实验值之间发现了良好的一致性,即95%置信度。拟议的方法还用于测定厄瓜多尔Comuna de Bajo Alto Provincia de El Oro海洋沉积物样品中的Sb。这些样品的五次重复测定的回收率在98-103%的范围内,因此在实际样品的分析中显示出可接受的准确性。 (C)2015 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号