【24h】

All-optical clock extraction from 10-Gbit/s NRZ-DPSK data using modal interference in a two-mode fiber

机译:使用双模光纤中的模态干扰从10 Gbit / s NRZ-DPSK数据中提取全光时钟

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

All-optical clock extraction from a 10-Gbit/s NRZ-DPSK input signal is demonstrated using modal interference in a two-mode fiber (TMF) and a mode-locked fiber ring laser. The TMF has a Mach-Zehnder configuration with two arms along the core and cladding regions. Using the difference in propagation delay between two arms, the non-return-to-zero differential phase shift keying (NRZ-DPSK) signal is converted to the return-to-zero on-off keying (RZ-OOK) signal. To obtain repetitive pulses as a clock signal from the RZ-OOK signal, a ring laser with a semiconductor optical amplifier (SOA) is used. Subsequently, the carrier-to-noise ratio (CNR) of the RZ-OOK and clock signals are enhanced up to 30 dB and 40 dB, respectively, compared to that of the original NRZ-DPSK signal. Also, the clock signal centered at 10 GHz has a low timing jitter of <1.6 ps. It is expected that this method can be applied to high speed fiber-optic systems of >10 Gbit/s due to its small time delay between the core and cladding regions.
机译:使用双模光纤(TMF)和锁模光纤环形激光器中的模态干扰,演示了从10 Gb / s NRZ-DPSK输入信号中提取全光时钟的方法。 TMF具有马赫曾德尔(Mach-Zehnder)配置,沿纤芯和包层区域有两个臂。利用两个臂之间传播延迟的差异,将不归零差分相移键控(NRZ-DPSK)信号转换为归零开关键控(RZ-OOK)信号。为了从RZ-OOK信号获得重复脉冲作为时钟信号,使用了带有半导体光放大器(SOA)的环形激光器。随后,与原始NRZ-DPSK信号相比,RZ-OOK和时钟信号的载波噪声比(CNR)分别提高了30 dB和40 dB。同样,以10 GHz为中心的时钟信号具有小于1.6 ps的低时序抖动。由于该方法在纤芯和包层区域之间的时间延迟较小,因此有望将其应用于大于10 Gbit / s的高速光纤系统。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号