...
首页> 外文期刊>RSC Advances >Tuning Ni nanoparticles and the acid sites of silica-alumina for liquefaction and hydrodeoxygenation of lignin to cyclic alkanes
【24h】

Tuning Ni nanoparticles and the acid sites of silica-alumina for liquefaction and hydrodeoxygenation of lignin to cyclic alkanes

机译:调节Ni纳米颗粒和硅铝酸位以木质素液化和加氢脱氧为环状烷烃

获取原文
获取原文并翻译 | 示例

摘要

A facile and effective method for the one-pot hydrodeoxygenation of enzymatic lignin to C-6-C-9 cycloalkanes is reported in liquid dodecane with 100 C% selectivity (approaching 50 wt% yield). The method enables 80 wt% lignin conversion by using Ni catalyst-supported amorphous silica-alumina (ASA) at 300 degrees C in the presence of 6 MPa H-2. The crucial factors to achieve direct lignin hydrodeoxygenation are the suitable balance in solvent selection and the design of active sites in the solvent liquid phase. The activity of Ni nanoparticles in dodecane leads to higher efficiency in the deconstruction of external C-O bonds in lignin. The consumption of lignin shifts the equilibrium of lignin solubility and weakens the impact of the relatively poor lignin solubility in dodecane for lignin depolymerization. The key element in controlling the activity of Ni-based catalysts is the specific external surface areas of diverse supports as well as the sizes of metallic Ni sites. This is probably because of the high external surface areas that can provide good contact opportunities for Ni sites in the lignin macromolecule. The efficient contact of active sites in the polymer reactant is the most important factor for such solid-solid reactions. The size and distribution of active Ni sites as well as the specific surface areas of Ni/ASA as modified by the different deposition precipitation times, reduction temperatures, and Ce additives can greatly affect the ability of a metal to attack the external C-O bonds of lignin. Furthermore, the acidity of the support (especially Bronsted acid sites) as modified by the Si/Al ratio of ASA significantly enhances the capabilities and alters the electronic structures of Ni nanoparticles for cleavage of the C-O linkages of lignin. This suggests that the synergy of acid and metal sites can be subtly tailored to strengthen the catalytic performance of Ni metallic sites. In addition, the presence of acidic sites catalyzes the dehydration of cyclic alcohols intermediates and facilitates the hydrodeoxygenation of the derived phenolic fragments to cyclic alkanes.
机译:据报道,在液态十二烷中具有100 C%的选择性(接近50 wt%的产率)的一种简单有效的方法将酶促木质素一锅加氢脱氧为C-6-C-9环烷烃。该方法通过在6 MPa H-2的存在下在300摄氏度下使用Ni催化剂负载的无定形二氧化硅-氧化铝(ASA)来实现80%的木质素转化率。实现木质素直接加氢脱氧的关键因素是溶剂选择和溶剂液相中活性位点设计的适当平衡。 Ni纳米粒子在十二烷中的活性导致木质素中外部C-O键解构的效率更高。木质素的消耗改变了木质素溶解度的平衡,并减弱了相对较差的木质素在十二烷中的溶解度对木质素解聚的影响。控制镍基催化剂活性的关键因素是各种载体的比表面积以及金属镍位的大小。这可能是由于高表面积可以为木质素大分子中的Ni位提供良好的接触机会。聚合物反应物中活性位点的有效接触是这种固-固反应的最重要因素。活性镍位点的大小和分布,以及由于不同的沉积沉淀时间,还原温度和Ce添加剂而改变的Ni / ASA比表面积,会极大地影响金属攻击木质素外部CO键的能力。此外,由ASA的Si / Al比改性的载体的酸度(特别是布朗斯台德酸位点)显着增强了用于裂解木质素的C-O键的Ni纳米颗粒的能力并改变了其电子结构。这表明可以巧妙地调整酸和金属位点的协同作用,以增强Ni金属位点的催化性能。另外,酸性位点的存在催化了环状醇中间体的脱水,并促进了衍生的酚片段加氢脱氧为环状烷烃。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号