...
首页> 外文期刊>Langmuir: The ACS Journal of Surfaces and Colloids >Limitations in the application of the gibbs equation to anionic surfactants at the air/water surface: Sodium dodecylsulfate and sodium dodecylmonooxyethylenesulfate above and below the CMC
【24h】

Limitations in the application of the gibbs equation to anionic surfactants at the air/water surface: Sodium dodecylsulfate and sodium dodecylmonooxyethylenesulfate above and below the CMC

机译:将gibbs方程应用于空气/水表面阴离子表面活性剂的局限性:CMC上方和下方的十二烷基硫酸钠和十二烷基单氧乙烯硫酸钠

获取原文
获取原文并翻译 | 示例
           

摘要

This is a second paper responding to recent papers by Menger et al. and the ensuing discussion about the application of the Gibbs equation to surface tension (ST) data. Using new neutron reflection (NR) measurements on sodium dodecylsulfate (SDS) and sodium dodecylmonooxyethylene sulfate (SLES) above and below their CMCs and with and without added NaCl, in conjunction with the previous ST measurements on SDS by Elworthy and Mysels (EM), we conclude that (i) ST measurements are often seriously compromised by traces of divalent ions, (ii) adsorption does not generally reach saturation at the CMC, making it difficult to obtain the limiting Gibbs slope, and (iii) the significant width of micellization may make it impossible to apply the Gibbs equation in a significant range of concentration below the CMC. Menger et al. proposed ii as a reason for the difficulty of applying the Gibbs equation to ST data. Conclusions i and iii now further emphasize the failings of the ST-Gibbs analysis for determining the limiting coverage at the CMC, especially for SDS. For SDS, adsorption increases above the CMC to a value of 10 × CMC, which is about 25% greater than at the CMC and about the same as at the CMC in the presence of 0.1 M NaCl. In contrast, the adsorption of SLES reaches a limit at the CMC with no further increase up to 10 × CMC, but the addition of 0.1 M NaCl increases the surface excess by 20-25%. The results for SDS are combined with earlier NR results to generate an adsorption isotherm from 2 to 100 mM. The NR results for SDS are compared to the definitive surface tension (ST) measurements of EM, and the surface excesses agree over the range where they can safely be compared, from 2 to 6 mM. This confirms that the anomalous decrease in the slope of EM's σ - ln c curve between 6 mM and the CMC at 8.2 mM results from changes in activity associated with a significant width of micellization. This anomaly shows that it is impossible to apply the Gibbs equation usefully from 6 to 8.2 mM (i.e., the lack of knowledge of the activity in this range is the same as above the CMC (8.2 mM)). It was found that a mislabeling of the original data in EM may have prevented the use of this excellent ST data as a standard by other authors. Although NR and ST results for SDS in the absence of added electrolyte show that the discrepancies can be rationalized, ST is generally shown to be less accurate and more vulnerable to impurities, especially divalent ions, than NR. The radiotracer technique is shown to be less accurate than ST-Gibbs in that the four radiotracer measurements of the surface excess are consistent neither with each other nor with ST and NR. It is also shown that radiotracer results on aerosol-OT are likely to be incorrect. Application of the mass action (MA) model of micellization to the ST curves of SDS and SLES through and above the CMC shows that they can be explained by this model and that they depend on the degree of dissociation of the micelle, which leads to a larger change in the mean activity, and hence the adsorption, for the more highly dissociated SDS micelles than for SLES. Previous measurements of the activity of SDS above the CMC were found to be semiquantitatively consistent with the change in mean activity predicted by the MA model but inconsistent with the combined ST, NR, and Gibbs equation results.
机译:这是第二篇论文,回应了Menger等人的最新论文。以及随后关于将Gibbs方程应用于表面张力(ST)数据的讨论。结合Elworthy和Mysels(EM)以前在SDS上对十二烷基硫酸钠(SDS)和十二烷基单氧乙烯硫酸钠(SLES)的CMC上下进行新的中子反射(NR)测量,以及添加和不添加NaCl的情况,我们得出的结论是:(i)二价离子的痕迹通常会严重损害ST的测量结果;(ii)在CMC处吸附通常不会达到饱和,从而难以获得极限吉布斯斜率;(iii)胶束化的显着宽度可能无法在低于CMC的显着浓度范围内应用Gibbs方程。 Menger等。提出ii是将Gibbs方程难以应用于ST数据的原因。结论i和iii现在进一步强调了ST-Gibbs分析在确定CMC(尤其是SDS)的极限覆盖率方面的失败。对于SDS,在CMC上方的吸附增加到10×CMC的值,该值比在CMC时大25%,与在存在0.1 M NaCl的情况下在CMC时大体相同。相比之下,SLES的吸附在CMC处达到极限,直到10×CMC才进一步增加,但添加0.1 M NaCl会使表面过量增加20-25%。 SDS的结果与早期的NR结果结合在一起,产生2至100 mM的吸附等温线。将SDS的NR结果与EM的确定表面张力(ST)测量值进行比较,并且表面多余部分在可以安全比较的范围内一致,为2至6 mM。这证实了EM的σ-ln c曲线在6 mM和8.2 mM处的CMC之间的斜率异常减小是由于与胶束化宽度显着相关的活性变化。这种反常现象表明,不可能有效地应用从6到8.2 mM的Gibbs方程(即,缺乏对该范围内活性的了解与在CMC之上(8.2 mM)相同)。已经发现,EM中原始数据的标签错误可能阻止了其他作者将该出色的ST数据用作标准。尽管在不添加电解质的情况下SDS的NR和ST结果表明,差异可以合理化,但与NR相比,ST通常显示的准确性较差,并且更容易受到杂质(尤其是二价离子)的影响。结果表明,放射性示踪剂技术不如ST-Gibbs准确,这是因为四个放射性示踪剂对表面多余物的测量既不相互一致,也不与ST和NR一致。还显示,气溶胶OT上的放射性示踪剂结果可能不正确。胶束化的质量作用(MA)模型通过CMC并通过CMC应用于SDS和SLES的ST曲线表明,可以用此模型解释它们,并且它们取决于胶束的解离程度,从而导致与SLES相比,离解程度更高的SDS胶束的平均活性变化更大,因此吸附也更大。发现先前对CDS上方SDS活性的测量与MA模型预测的平均活性变化半定量一致,但与ST,NR和Gibbs方程的组合结果不一致。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号