...
首页> 外文期刊>Macromolecules >Synthesis and characterization of network single ion conductors based on comb-branched polyepoxide ethers and lithium bis(allylmalonato)borate
【24h】

Synthesis and characterization of network single ion conductors based on comb-branched polyepoxide ethers and lithium bis(allylmalonato)borate

机译:基于梳状支化聚环氧醚和双(烯丙基铝硼酸)硼酸锂的网络单离子导体的合成与表征

获取原文
获取原文并翻译 | 示例

摘要

Network single ion conductors (NSICs) based on comb-branch polyepoxide ethers and lithium bis(allylmalonato) borate have been synthesized and thoroughly characterized by means of ionic conductivity measurements, electrochemical impedance, and cycling in symmetrical Li/Li half cells, Li/V6O13 full cells in which a NSIC was used as both binder and electrolyte in the cathode electrode and as the electrolyte separator membrane, and by dynamic mechanical analysis (DMA). The substitution of the trimethylene oxide (TMO) unit into the side chains in place of ethylene oxide (130) units increased the polymer-ion mobility (lower glass transition temperature). However, the ionic conductivity was nearly one and half orders of magnitude lower than the corresponding pure EO-based single ion conductor at the same salt concentration, which may be ascribed to the lower dielectric constant of the TMO side chains that result in a lower concentration of free conducting lithium cations. For a highly cross-linked system (EO/Li = 20), only 47 wt % plasticizing solvent (ethylene carbonate (EC)/ethyl methyl carbonate (EMC), l/l by wt) could be taken up, and the ionic conductivity was only increased by I order of magnitude over the dry polyelectrolyte, while for a less densely cross-linked system (EO/Li = 80), up to 75 wt % plasticizer could be taken up and the ionic conductivity was increased by nearly 2 orders of magnitude. A Li/Li symmetric cell that was cycled at 85 degrees C at a current density of 25 mu A cm(-2) showed no concentration polarization or diffusional relaxation, which was consistent with a lithium ion transference number of 1. However, both the bulk and interfacial impedance increased after 20 cycles, which was apparently due to continued cross-linking reactions within the membrane and on the surface of the lithium electrodes. A Li/V6O13 full cell constructed using a single ion conductor gel (propylene carbonate (PC)/EMC, 1/1 in wt) was cycled at 25 degrees C at a current density of 25 mu A cm(-2) and showed an initial capacity of 268 mAh g(-1) of V6O13, which stabilized at around 200 mAh g(-1) after the first 20 cycles. During the DMA measurements on the NSICs, it was found that besides the main g, ass transition (a transition) there was a distinct secondary glass transition (P transition) for NSICs having five EO units in the side chains, while this (the secondary transition) was not clearly visible in the network single ion conductors (NSICs) with shorter side chains (two, three, and four EO units). The main glass transition (alpha transition) was attributed to the whole network structure of the single ion conductors and secondary,glass transition (beta transition) appeared to be due to the complexation of lithium by the side-chain chains. Both the main glass transition and the secondary transition were found to shift to higher temperature with increasing salt concentration.
机译:合成了基于梳状分支聚环氧醚和双(烯丙基铝硼酸)硼酸锂的网络单离子导体(NSIC),并通过离子电导率测量,电化学阻抗和在对称的Li / Li半电池Li / V6O13中循环来全面表征通过动态机械分析(DMA)在其中将NSIC用作阴极电极中的粘合剂和电解质以及电解质隔膜的全电池。取代环氧乙烷(130)单元而将三环氧丙烷(TMO)单元取代为侧链增加了聚合物离子的迁移率(较低的玻璃化转变温度)。但是,在相同的盐浓度下,离子电导率比相应的纯EO基单离子导体低将近一个半个数量级,这可能归因于TMO侧链的介电常数较低,导致其浓度较低。自由导电的锂阳离子。对于高度交联的体系(EO / Li = 20),仅可吸收47 wt%的增塑溶剂(碳酸亚乙酯(EC)/碳酸乙基甲基酯(EMC),按重量计为1 / l),并且离子电导率相对于干燥的聚电解质仅增加了一个数量级,而对于密度较低的交联体系(EO / Li = 80),可吸收高达75 wt%的增塑剂,并且离子电导率增加了近2个数量级数量级。 Li / Li对称电池在85摄氏度下以25μA cm(-2)的电流密度循环,没有浓度极化或扩散弛豫,这与锂离子迁移数1一致。体积阻抗和界面阻抗在20个循环后增加,这显然是由于膜内和锂电极表面上持续的交联反应。使用单离子导体凝胶(碳酸亚丙酯(PC)/ EMC,重量为1/1)构建的Li / V6O13全电池在25摄氏度下以25μA cm(-2)的电流密度循环,并显示出V6O13的初始容量为268 mAh g(-1),在前20个循环后稳定在200 mAh g(-1)左右。在NSIC上进行DMA测量期间,发现除了主g,驴跃迁(跃迁)外,在侧链上有五个EO单元的NSIC还存在明显的二次玻璃跃迁(P跃迁)。在具有较短侧链(两个,三个和四个EO单元)的网络单离子导体(NSIC)中看不到清晰可见的过渡。主要的玻璃化转变(α转变)归因于单个离子导体的整个网络结构,而第二个玻璃化转变(β转变)似乎归因于锂通过侧链链的络合。发现随着盐浓度的增加,主要的玻璃化转变温度和次要的转变温度都向较高的温度转变。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号