...
首页> 外文期刊>Geophysical Research Letters >Three-dimensional deformation mapping of a dike intrusion event in Sakurajima in 2015 by exploiting the right- and left-looking ALOS-2 InSAR
【24h】

Three-dimensional deformation mapping of a dike intrusion event in Sakurajima in 2015 by exploiting the right- and left-looking ALOS-2 InSAR

机译:利用左右视线的ALOS-2 InSAR,2015年樱岛大堤入侵事件的三维变形映射

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

One of the limitations of the interferometric synthetic aperture radar (InSAR) is its one-dimensional measurement capability. Although three-dimensional (3-D) deformation can be studied if there are three or more measurements with different viewing geometries, it has not been executed because almost all SAR data are acquired using a right-looking geometry. For the Sakurajima volcanic activity on 15 August 2015, ALOS-2 conducted SAR observations from four different viewing directions, ascending/descending and right-/left-looking, enabling the retrieval of 3-D deformation data only from the InSAR results. We have retrieved 3-D deformation with high precision and resolution by a weighted least squares approach. Expansive deformation of over 10 cm has been observed with standard errors of 0.8, 3.4, and 0.7 cm for east-west, north-south, and up-down components, respectively. It is inferred that a dike of 1.7 x 10(6)m(3) volume intruded beneath the Showa crater at a depth of 0.4-1.2 km.
机译:干涉式合成孔径雷达(InSAR)的局限性之一是其一维测量能力。尽管如果存在三个或三个以上具有不同观察几何形状的测量结果,可以研究三维(3-D)变形,但由于几乎所有的SAR数据都是使用右视几何形状来获取的,因此尚未执行。对于2015年8月15日的樱岛火山活动,ALOS-2从四个不同的观察方向(升/降和右/左视)进行了SAR观测,从而只能从InSAR结果中检索3D变形数据。我们已经通过加权最小二乘法获得了高精度和高分辨率的3D变形。观察到东西向,南北向和上下分量的膨胀变形超过10 cm,标准误差分别为0.8、3.4和0.7 cm。可以推断,有一个1.7 x 10(6)m(3)的堤防侵入了Showa火山口下方,深度为0.4-1.2 km。

著录项

相似文献

  • 外文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号