...
首页> 外文期刊>Bioresource Technology: Biomass, Bioenergy, Biowastes, Conversion Technologies, Biotransformations, Production Technologies >A comparison of liquid hot water and steam pretreatments of sugar cane bagasse for bioconversion to ethanol
【24h】

A comparison of liquid hot water and steam pretreatments of sugar cane bagasse for bioconversion to ethanol

机译:甘蔗渣液体热水和蒸汽预处理生物转化为乙醇的比较

获取原文
获取原文并翻译 | 示例

摘要

Sugar cane bagasse was pretreated with either liquid hot water (LHW) or steam using the same 251 reactor. Solids concentration ranged from 1% to 8% for LHW pretreatment and was greater than or equal to 50% for steam pretreatment. Reaction temperature and time ranged from 170 to 230 degreesC and 1 to 46 min, respectively. Key performance metrics included fiber reactivity, xylan recovery, and the extent to which pretreatment hydrolyzate inhibited glucose fermentation. In four cases, LHW pretreatment achieved greater than or equal to 80% conversion by simultaneous saccharification and fermentation (SSF), greater than or equal to 80% xylan recovery, and no hydrolyzate inhibition of glucose fermentation yield. Combined effectiveness was not as good for steam pretreatment due to low xylan recovery. SSF conversion increased and xylan recovery decreased as xylan dissolution increased for both modes. SSF conversion, xylan dissolution, hydrolyzate furfural concentration, and hydrolyzate inhibition increased, while xylan recovery and hydrolyzate pH decreased, as a function of increasing LHW pretreatment solids concentration (14%). These results are consistent with the notion that autohydrolysis. plays an important, if not exclusive, role in batch hydrothermal pretreatment. Achieving concurrently high (greater than 90%) SSF conversion and xylan recovery will likely require a modified reactor configuration (e.g. continuous percolation or base addition) that better preserves dissolved xylan. (C) 2001 Elsevier Science Ltd. All rights reserved. [References: 37]
机译:使用相同的251反应器,用液态热水(LHW)或蒸汽对甘蔗渣进行预处理。 LHW预处理的固体浓度范围为1%至8%,而蒸汽预处理的固体浓度大于或等于50%。反应温度和时间分别为170至230℃和1至46分钟。关键性能指标包括纤维反应性,木聚糖回收率以及预处理水解产物抑制葡萄糖发酵的程度。在四种情况下,LHW预处理通过同时糖化和发酵(SSF)实现了大于或等于80%的转化率,大于或等于80%的木聚糖回收率,并且没有水解产物抑制葡萄糖发酵的产量。由于木聚糖回收率低,联合效果不如蒸汽预处理好。随着两种模式木聚糖溶解度的增加,SSF转化率增加,木聚糖回收率降低。 SSF转化率,木聚糖溶出度,水解产物糠醛浓度和水解产物抑制作用增加,而木聚糖回收率和水解产物pH下降,这与LHW预处理固体浓度的增加(14%)有关。这些结果与自动水解的观点是一致的。在分批水热预处理中起着重要的作用,即使不是唯一的作用。要同时达到较高的SSF转化率(大于90%)和木聚糖回收率,可能需要改进反应器配置(例如连续渗滤或添加碱),以更好地保存溶解的木聚糖。 (C)2001 Elsevier ScienceLtd。保留所有权利。 [参考:37]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号