...
首页> 外文期刊>Colloids and Surfaces, A. Physicochemical and Engineering Aspects >The mechanism of wet-strength development of cellulose sheets prepared with polyamideamine-epichlorohydrin (PAE) resin
【24h】

The mechanism of wet-strength development of cellulose sheets prepared with polyamideamine-epichlorohydrin (PAE) resin

机译:聚酰胺胺-表氯醇(PAE)树脂制备的纤维素片的湿强度发展机理

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

The mechanism of wet-strength development of cellulose sheets prepared with typical wet-strength additive, polyamideamine-epichlorohydrin resin (PAE), was studied by some analytical techniques. PAE-containing sheets were prepared from cellulose fibers with different carboxyl contents by either internal addition of PAE to slurries of cellulose fibers or soaking treatment of once-dried cellulose sheets with aqueous PAE solutions. The results showed that carboxyl groups in cellulose fibers behaved as anionic retention sites of cationic PAE molecules for both internal addition of PAE in the sheet-making process and soaking treatment of cellulose sheets with PAE solutions. Moreover, wet-tensile strength of the PAE-containing sheets was clearly improved by heating treatment of the sheets at 110 degrees C for 10 min, when the cellulose fibers of the sheets clearly had carboxyl groups. FNR analysis of PAE films showed that ester bond formation between carboxyl groups at the end of polyamideamine chains in PAE and azetidinium groups of PAE, i.e. within PAE molecules, are possible to occur at least in heated PAE films. PAE-containing cellulose sheets were then subjected to cellulase treatment to obtain PAE-rich fractions in the sheets by removing most of cellulose and hemicellulose fractions without any interactions with PAE. The cellulase-treated residues obtained in the yields of about 1% were analyzed by FT-IR. The result revealed that significant amounts of ester bonds formed between azetidinium groups of PAE and carboxyl groups of cellulose fibers were present in the PAE-containing cellulose sheets, and that these ester bonds increased by heating treatment of the sheets. Thus, it was concluded that wet-strength development of PAE-containing cellulose sheets is primarily ascribed to the ester bond formation between azetidinium groups of PAE and carboxyl groups of cellulose fibers, i.e. the covalent bond formation. (C) 2007 Elsevier B.V. All rights reserved.
机译:通过一些分析技术研究了用典型的湿强度添加剂聚酰胺胺-表氯醇树脂(PAE)制备的纤维素片的湿强度发展机理。含PAE的片材是通过将PAE内部添加到纤维素纤维浆液中或用PAE水溶液浸泡一次干燥的纤维素片材后,由具有不同羧基含量的纤维素纤维制成的。结果表明,在制片过程中内部添加PAE和用PAE溶液浸泡处理纤维素片材时,纤维素纤维中的羧基均作为阳离子PAE分子的阴离子保留位。此外,当片材的纤维素纤维明显具有羧基时,通过在110℃下对该片材进行10分钟的热处理,可以明显提高含PAE的片材的湿拉伸强度。对PAE膜的FNR分析表明,至少在加热的PAE膜中,PAE中聚酰胺胺链末端的羧基与PAE的氮杂环丁烷基团之间(即PAE分子内)的酯键形成可能发生。然后对含PAE的纤维素片进行纤维素酶处理,以通过去除大部分纤维素和半纤维素级分而不与PAE相互作用而在片中获得富含PAE的级分。通过FT-IR分析以约1%的产率获得的经纤维素酶处理的残余物。结果表明,在含PAE的纤维素片材中存在大量PAE的氮杂环丁烷基与纤维素纤维的羧基之间形成的酯键,并且这些酯键通过片材的热处理而增加。因此,可以得出结论,含PAE的纤维素片的湿强度发展主要归因于PAE的氮杂环丁鎓基团与纤维素纤维的羧基之间的酯键形成,即共价键形成。 (C)2007 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号