首页> 外文期刊>Colloids and Surfaces, A. Physicochemical and Engineering Aspects >Antifouling properties of TiO2: Photocatalytic decomposition and adhlesion of fatty and rosin acids, sterols and lipophilic wood extractives
【24h】

Antifouling properties of TiO2: Photocatalytic decomposition and adhlesion of fatty and rosin acids, sterols and lipophilic wood extractives

机译:TiO2的防污性能:脂肪和松香酸,固醇和亲脂性木材提取物的光催化分解和粘合

获取原文
获取原文并翻译 | 示例
           

摘要

Titanium dioxide has the well-known property to catalyze the decomposition of organic substances and also becomes strongly hydrophilic under UV illumination, rendering TiO2 interesting as an antifouling material. The kinetics of decomposition and removal of Langmuir-Blodgett or spin-coated films of stearic, dehydroabietic, capric and linoleic acid, beta-sitosterol, wood resin components and colloidal wood resin particles from a TiO2 surface was measured with a quartz crystal microbalance with dissipation monitoring (QCM-D). In the beginning of the degradation measurements, a 0-3 min long initation period, with hindered or prevented degradation was often detected. After the initiation period the degradation continued with relatively constant rate, until it decelerated again near the end of experiment. The primary mechanism of removal of the films was photocatalytic degradation, but it was shown that the penetration or formation of water at the TiO2/film interface and the flow of oxygen to the interface also are of importance. Correlation of the flow of oxygen to the rate of photocatalytic degradation was observed. Adhesion of wood resin components to TiO2 in aqueous solutions was determined by contact angle measurement. UV illumination reduced the adhesion of liquid wood extractives on TiO2 A model focused on photocatalytic cleaning mechanisms in solution is presented. Possible applications in papermaking are discussed. (c) 2006 Elsevier B.V. All rights reserved.
机译:二氧化钛具有众所周知的催化有机物分解的特性,并且在紫外线照射下也具有很强的亲水性,从而使TiO2成为一种有趣的防污材料。用石英晶体微量天平测量耗散的Langmuir-Blodgett分解和去除硬脂酸,脱氢松香酸,癸酸和亚油酸,β-谷甾醇,木材树脂组分和胶体木材树脂颗粒的TiO2表面分解和旋涂膜的动力学。监控(QCM-D)。在降解测量开始时,通常会检测到0-3分钟长的引发时间,其中存在抑制或阻止的降解。在开始阶段之后,降解以相对恒定的速率继续进行,直到在实验即将结束时再次减速。去除膜的主要机理是光催化降解,但是已经表明水在TiO2 /膜界面处的渗透或形成以及氧气向界面的流动也很重要。观察到氧气流量与光催化降解速率的相关性。通过接触角测量确定木材树脂组分在水溶液中对TiO2的附着力。紫外线照射降低了液态木材提取物在TiO2上的附着力。提出了一种致力于溶液中光催化清洁机理的模型。讨论了在造纸中可能的应用。 (c)2006 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号