The Influence of Polymer Processing Additivies (PPAs) on The Surface and Optical Properties of Polyolefin Plastomer Blown Film

摘要

Polyolefin plastomer films formulated with slip and antiblock were blown on a wide die gap with and without two DynamarTM polymer pro- cessing additives (PP As). A wide die gap was used so that melt fracture-free film could be obtained with no PP A present for comparison purposes. The films were analyzed for the following properties: surface tension (on treated films), gloss, haze, clarity, transmittance, hot tack, heat seal, COF and block. In addition, the surface of films was examined using ESCA (Electron Spectroscopy for Chemical Analysis) and SSIMS (Static Secondary Ion Mass Spectrometry) to determine the surface chemical composition. PP As when used at typical dose levels were shown to have essentially no effect on the surface and optical properties of plastomer films.