...
首页> 外文期刊>Journal of Petroleum Science & Engineering >Effect of silica sand size on the formation kinetics of CO2 hydrate in porous media in the presence of pure water and seawater relevant for CO2 sequestration
【24h】

Effect of silica sand size on the formation kinetics of CO2 hydrate in porous media in the presence of pure water and seawater relevant for CO2 sequestration

机译:在纯净水和海水存在下,硅砂粒度对多孔介质中CO2水合物形成动力学的影响

获取原文
获取原文并翻译 | 示例

摘要

Understanding the kinetics of carbon dioxide (CO2) hydrate formation in pure water, seawater and porous media aids in developing technologies for CO2 gas storage, carbon capture and sequestration (CCS) and potentially for methane production from methane hydrates. The present work is focused on understanding the kinetics of CO2 hydrate formation in pure water and seawater at an initial formation pressure of 6 MPa (providing a driving force of about 4.0 MPa) and a formation temperature of 276.15 K with 75% water saturation in three silica sand particle sizes (0.16 mm, 0.46 mm and 0.92 mm). The seawater (3.3 wt% salinity) used in the present study is obtained from sea coast of Chennai (India). It is observed that the gas consumption of CO2 in hydrate is more for smaller silica sand particle and decreases as the size of the sand increases. The total gas consumed at the end of the seawater experiment is found to be less than the gas consumed at the end of the pure water experiment This is due to the fact that salts in seawater act as a thermodynamic inhibitor resulting in lower gas consumption of CO2 in hydrate. The average rate of hydrate formation observed is optimum in 0.46 mm particles and is observed to be higher as compared to 0.16 and 0.92 mm particles over 10 h experimental time. This indicates that 0.46 mm silica sand provides an optimum environment for efficient hydrate formation. The study can be useful to understand the suitability of potential sandstone reservoir for CO2 sequestration in the form of hydrate in the presence of saline formation water.
机译:了解纯净水,海水和多孔介质中二氧化碳(CO2)水合物形成的动力学有助于开发用于CO2气体存储,碳捕获和封存(CCS)以及潜在地由甲烷水合物生产甲烷的技术。本工作着重于了解纯净水和海水中初始地层压力为6 MPa(提供约4.0 MPa的驱动力)和地层温度为276.15 K,水饱和度为75%的情况下在纯净水和海水中形成CO2水合物的动力学。硅砂粒度(0.16毫米,0.46毫米和0.92毫米)。本研究中使用的海水(盐度为3.3 wt%)来自印度钦奈的沿海地区。可以看出,较小的硅砂颗粒中水合物中CO2的气体消耗量更大,并且随着砂子尺寸的增加而降低。发现在海水实验结束时消耗的总气体少于纯水实验结束时消耗的气体。这是由于以下事实:海水中的盐起热力学抑制剂的作用,从而降低了CO2的气体消耗在水合物中。在10小时的实验时间内,观察到的平均水合物形成速率在0.46 mm的颗粒中最佳,并且与0.16和0.92 mm的颗粒相比更高。这表明0.46毫米的硅砂为有效的水合物形成提供了最佳环境。该研究对于了解潜在的砂岩储层是否适合在盐分地层水存在下以水合物形式封存CO 2很有帮助。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号