首页> 外文期刊>Journal of Polymer Materials >Chemical Modification of Jute Fabric with Ethylene Glycol and its Mixtures with Glyoxal and Aminosilicone Compound Under Different Catalyst Systems for Improving its Textile Related Properties and Thermal Behaviour
【24h】

Chemical Modification of Jute Fabric with Ethylene Glycol and its Mixtures with Glyoxal and Aminosilicone Compound Under Different Catalyst Systems for Improving its Textile Related Properties and Thermal Behaviour

机译:黄麻织物在不同催化剂体系下用乙二醇及其与乙二醛和氨基硅氧烷化合物的混合物进行化学改性,以改善织物的相关性能和热性能

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

Raw/bleached jute fabric was subjected to (a) controlled/limited oxidation using K2S2O8 and NalO4 pretreatment to produce oxy-jute substrate and subsequently to (b) treatment with ethylene glycol under two different catalyst system {MgCl2 or Al2(SO4)3} following pad-cure (thermal treatment) technique for improving its textile related properties and thermal behaviour.Between NalO4 and K2S2O8 as oxidizing agent,NalO4 is much stronger and causes damages to the fiber,while K2S2O8 pretreatment followed by a short UV-light exposure is found to be milder but advantageous for subsequent modification of the oxy-jute substrate with ethylene glycol.The proposed reaction mechanism is also supported from FTIR and DSC analyses.Changes in important textile related properties for modification of the oxy-jute substrate under different conditions of treatment have been investigated and based on the observed results;all the reaction parameters have been optimized.The optimized reaction conditions found are:K2S2O8 - 0.5% owf,time of UV-light exposure after the K2S2O8 treatment-15 min,concentration of ethylene glycol - 8% owf,concentration of Al2 (SO4)3 - 5% owf,curing temperature - 130°C and curing time - 10 min.The 0.5% K2S2O8 pretreated oxy-jute substrate was also modified with different proportions of mixtures of ethylene glycol and aminosilicone and also with mixtures of ethylene glycol and glyoxal.Treatment with the overall 8% (owf) dose of application for a 30:70 ratio of mixture of ethylene glycol and aminosilicone to the K2S2O8 pretreated oxy-jute fabric renders the fabric a higher weight gain and crease recovery angle along with increased thermal stability,but also with marginally higher tenacity loss.Use of glyoxal in any proportion in the mixture of ethylene glycol and glyoxal for such chemical modification does not produce any property advantages and causes much higher loss in tenacity.Most of the said chemical modifications except the initial K2S2O8 pretreatment show some increase in crystallinity percentage due to positive alteration of apparent orientational effect owing to some crosslink formed by the said modifications.Study of surface morphology of differently modified bleached jute fabric reveals that application of 30:70 ratio of mixture of ethylene glycol and aminosilicone on oxy-jute fabric renders it much uniform and smooth cover of polymeric film suppressing the surface etching and damages occurred in initial K2S2O8 oxidative treatment.
机译:对生/漂白的黄麻织物进行(a)使用K2S2O8和NalO4预处理进行受控/有限氧化,以生成黄麻基料,然后(b)在两种不同的催化剂体系{MgCl2或Al2(SO4)3}下用乙二醇处理在NalO4和K2S2O8之间作为氧化剂,NalO4的强度要强得多,并会损坏纤维,而K2S2O8预处理后短时间暴露在紫外线下是为了改善其纺织品相关的性能和热性能。 FTIR和DSC分析也支持了拟议的反应机理。在不同条件下,重要的纺织品相关性能的变化对OX-Jute底物进行了改性。对反应进行了研究并根据观察结果进行了优化;对所有反应参数进行了优化。 re:K2S2O8-0.5%owf,K2S2O8处理后的紫外线照射时间-15分钟,乙二醇浓度-8%owf,Al2(SO4)3浓度-5%owf,固化温度-130°C固化时间-10分钟。还用不同比例的乙二醇和氨基硅氧烷混合物以及乙二醇和乙二醛混合物对0.5%K2S2O8预处理的氧麻黄底物进行了改性,以总8%(owf)的剂量进行处理乙二醇和氨基硅氧烷的比例为30:70的混合料与K2S2O8预处理的氧黄麻织物相比,可使织物具有更高的增重和折痕回复角,同时具有更高的热稳定性,但同时也略微增加了韧性损失。在乙二醇和乙二醛的混合物中进行任何比例的化学修饰不会产生任何性能优势,并且会导致韧性损失更高。除最初的K2S2O8预处理外,大多数上述化学修饰都显示出一些由于所述改性形成的一些交联,由于表观取向作用的正改变而导致结晶度百分比增加。对不同改性的漂白黄麻织物的表面形态的研究表明,将乙二醇和氨基硅氧烷的混合物以30:70的比例应用于氧-黄麻织物可以使聚合物膜更加均匀,光滑地覆盖,从而抑制了表面蚀刻以及在最初的K2S2O8氧化处理中发生的损坏。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号