...
首页> 外文期刊>Journal of nanoparticle research: An interdisciplinary forum for nanoscale science and technology >Effect of silver addition on the formation and deposition of titania nanoparticles produced by liquid flame spray
【24h】

Effect of silver addition on the formation and deposition of titania nanoparticles produced by liquid flame spray

机译:银的添加对液态火焰喷涂二氧化钛纳米粒子形成和沉积的影响

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

In this study, liquid flame spray (LFS) was used to produce titania, silver and silver-titania deposits of nanoparticles. Titanium(IV)ethoxide (TEOT) and silver nitrate in ethanol solutions were used as precursors and sprayed into turbulent hydrogen-oxygen flame. Production rates of 1.5-40 mg/min of titania were used with silver additions of 1, 2, 4, and 8 wt% compared to titania. Nanoparticle deposits were collected by thermophoretic sampling at six different axial distances from the flame torch head: 3, 5, 10, 12, 15, and 20 cm, of which the all but the last one occurred inside the flame. The deposit samples were analysed by TEM and SAED analysis. The powder samples of the particles were also collected by electric precipitator to XPS and specific surface area analysis. Particle size and effective density after the flame in the aerosol were analysed with SMPS and ELPI. The results from the previous studies i.e. controlling the particle size by setting the production rates of the particles were seen to apply also for this binary system. Characterisation of the deposits showed that when the substrate is inserted into the flame, in the beginning of the flame the deposit is formed by gas phase deposition whereas further down the flame the particles are first formed in the gas phase and then deposited. The location of the transition from gas phase deposition to gas phase nucleation prior to deposition depends on chemical/physical properties (e.g. thermodynamics and gas phase interactions) of the precursor, precursor concentration in the flame and also flame temperature profile. Therefore, the deposit collection distance from the burner also affected the collected particle size and degree of agglomeration. The two component deposits were produced in two different ways: one-step method mixing both precursors in the same solute, and two-step method spraying each precursor separately. The particle morphology differs between these two cases. In one-step method the primary (d (TEM)) and agglomerate particle size (d (SMPS)) decreased with the amount of silver addition, verifying the fact that when present, the silver has a clear effect on the titania nanoparticle formation and growth.
机译:在这项研究中,液体火焰喷雾(LFS)用于产生纳米颗粒的二氧化钛,银和二氧化钛银沉积物。乙醇溶液中的乙醇钛(IV)钛(TEOT)和硝酸银用作前体,并喷入湍流的氢氧火焰中。与二氧化钛相比,二氧化钛的生产率为1.5-40 mg / min,银的添加量为1、2、4和8 wt%。通过热泳采样在距火焰炬头六个不同的轴向距离处收集纳米颗粒沉积物:3、5、10、12、15和20 cm,除最后一个以外,所有沉积物都位于火焰内部。沉积物样品通过TEM和SAED分析进行分析。还通过电除尘器将颗粒的粉末样品收集到XPS和比表面积分析中。使用SMPS和ELPI分析了火焰在气溶胶中的粒径和有效密度。先前研究的结果,即通过设定颗粒的生产率控制颗粒尺寸,也被认为也适用于该二元体系。沉积物的特征表明,当将基材插入火焰中时,在火焰开始时,沉积物是通过气相沉积形成的,而在火焰的更深处,颗粒首先在气相中形成,然后沉积。在沉积之前从气相沉积到气相成核的转变的位置取决于前体的化学/物理性质(例如热力学和气相相互作用),火焰中前体的浓度以及火焰温度曲线。因此,距燃烧器的沉积物收集距离也影响了收集的颗粒大小和附聚程度。这两种沉积物的沉积有两种不同的方式:将两种前体混合在同一溶质中的一步法,以及分别喷涂每种前体的两步法。这两种情况之间的粒子形态不同。在一步法中,初级(d(TEM))和附聚物粒度(d(SMPS))随着添加的银量的减少而减小,证明了以下事实:存在时,银对二氧化钛纳米颗粒的形成和清除具有明显的影响。增长。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号